Table of Contents
Advertisement
Assign Handset No.
Select and press
r
Select number. Only numbers
that have not been assigned
are displayed.
Press the Display key to save
§Save§
the input.
Using a handset as a
room monitor
When the room monitor function is acti-
vated and the handset detects a specific
noise level, the handset automatically
calls a destination phone number. That
phone number can be either another
handset or an external number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
When the room monitor is activated, all
keys are locked except the End Call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringer and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off. When the room
monitor function is activated, all of the
handset keys are deactivated except for
the Display keys.
If you accept an incoming call, the room
monitor is suspended for the duration of
the call, but the function remains acti-
vated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
.
§OK§
Using a handset as a room monitor
Warning!
u
Always check the operation of the
room monitor before use. For
example, test its sensitivity.
Check the connection if you are
forwarding the room monitor to
an outside number.
u
When the function is switched on,
the handset's operating time is con-
siderably reduced. If necessary,
place the handset in the charging
cradle.
u
Ideally, the handset should be posi-
tioned 1 to 2 meters (3 to 6 feet)
away from the baby. The micro-
phone must be directed toward the
baby.
u
The connection to which the room
monitor is forwarded must not be
blocked by an activated voice mail.
Activating the room monitor and
entering the destination number
É
¢
¢
v
Room Monitor
¤
You can enter data in the following
fields:
Activation:
Select
to activate.
On
Alarm to:
Select
Internal
or External.
External number: Select the number
from the directory (press Display key
ö
) or enter it directly.
Internal number: Select Display key
¢
Select handset or
§Change§
you want to call all registered handsets
¢
.
§OK§
In idle status, the destination number
or the internal destination number is
displayed.
Sensitivity:
Select noise level sensitivity
High).
¤
Press
to save the settings.
§Save§
if
Call All
(Low
or
47
Advertisement
Table of Contents
