Gigaset S810H User Manual page 34

Using a handset as a Room Monitor (Babyphone)
Warning!
u Always check the operation of the
Room Monitor before use. For example,
test its sensitivity. Check the connec-
tion if you are diverting the Room Mon-
itor to an external number.
u When the function is switched on, the
handset's operating time is considerably
reduced. If necessary, place the handset
in the charger. This ensures that the bat-
tery does not run down.
u Ideally the handset should be positioned
1 to 2 metres away from the baby. The
microphone must be directed towards
the baby.
u The connection to which the Room Mon-
itor is diverted must not be blocked by an
activated Answering Machine.
Activating the Room Monitor and
entering the destination number
É
v
¢ ¢ Room Monitor
¤ You can enter data in the following fields:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number from
the Directory (press display key
it manually.
Internal number: Select display key
¢ . Select handset or Call All to call all regis-
tered handsets ¢
In idle status, the destination number or the
internal destination number is displayed.
Two Way Talk:
Switch the handset's speaker on or off
(select On or Off).
Sensitivity:
Select the sensitivity of the sound level
(select Low or High).
¤ Press
§Save§
to save the settings.
32
ö
) or enter
§Change§
§OK§
.
When the Room Monitor function is activated,
the idle display appears as shown below:
i V
07:15
Á
INT 1 22 Oct
Room Monitor
0891234567
OFF Options
Changing the set destination number
É
v
¢ ¢ Room Monitor
¤ Enter and save number as described in
"Activating the Room Monitor and entering
the destination number" (¢ page 32).
Cancelling/deactivating the
Room Monitor
Press the end call key
when the Room Monitor is activated.
In idle status, press the display key
deactivate Room Monitor mode.
Deactivating the Room Monitor
remotely
Prerequisites: The phone must support tone
dialling and the Room Monitor should be set
for an external destination number.
¤ Accept the call from the Room Monitor and
9 ;
press keys .
The Room Monitor function will deactivate
after the call ends. There are no further Room
Monitor calls. The other Room Monitor settings
on the handset (e.g., no ringtone) will remain
activated until you press the display key
on the handset.
To reactivate the Room Monitor with the same
phone number:
¤ Turn on the activation again and save with
§Save§
(¢ page 32).
a
to cancel the call
§OFF§
to
§OFF§