Clarity Fortissimo User Manual page 42

Extra loud remote controlled speakerphone (with optional pendant)
Table of Contents

Advertisement

NOTES:
1. Your pendant is equipped with a head
phone/neckloop jack; use headphones/
neckloop to add privacy for your call;
when headphones are used, the speaker-
phone speaker is disabled.
2. Your pendant is equipped with a local
microphone, to ensure your voice is
transmitted properly during a call.
3. Your pendant is equipped with a volume
control that controls the volume of the
speakerphone audio.
4. Your pendant is equipped with a switch
jack – use an external switch (3.5mm
plug, purchased separately) to replace
the button on your pendant.
5. Your pendant has additional modes
that can be enabled (to be activated by
press-and-hold the pendant button for 3
seconds); you can only choose one op-
tion at a time. (Both cannot be active at
the same time.)
Sick bell mode
– Default setting is ON.
– This enables your pendant to transmit
a message towards the speakerphone.
(In case it is in a different location)
– Press and hold the button on your
pendant for 3 seconds, then say "I
need help" (or any type of voice
messages) to transmit this message
to the speakerphone. Anyone in the
42
PHONE OPERATIONS
vicinity of the speakerphone can hear
your message and provide the help
you need.
Note: This mode does NOT enable a two-
way conversation; it is for the wearer of the
pendant to transmit a message towards the
person near the speakerphone.
Note: You cannot use the "Sick Bell" or
"Quick Dial" modes if you use a switch
plugged into your pendant.
Quick Dial mode
– Default setting is ON.
– If a pendant is registered to your
speakerphone, one of the Phonebook
records can be set as your "Quick
Access" contact. (This is part of the
Additional Features associated with
your phonebook records – accessible
during Edit or Add modes for your
phonebook records).
– Press and hold the pendant button for
3 seconds to activate this mode.
The speakerphone dials out the phone-
book record associated with the "Quick
Dial" feature; upon answering the call, you
can start a conversation with the contact
in your phonebook that is associated with
this feature; press the button again to end
the conversation.
In case you are unable to end the call, the
person contacted via this feature can end
the conversation by pressing twice the "5"
key on their phone.

Advertisement

Table of Contents
loading

Table of Contents