Yamaha RX10GTX Owner's Manual page 62

Periodic maintenance
1. V-belt
4. Remove the V-belt from the secondary
sheave assembly and primary sheave
assembly.
5. Temporarily install the new V-belt on the
secondary sheave assembly only, and
then measure the V-belt position. Do not
force the V-belt between the sheaves; the
secondary sliding and fixed sheaves
must touch each other.
1. Edge of the secondary sheave assembly
2. V-belt position
56
Standard V-belt position:
From 1.5 mm (0.06 in) above the edge
of the secondary sheave assembly to
0.5 mm (0.02 in) below the edge.
6. If the V-belt position is incorrect, adjust it
by removing or adding a spacer on each
V-belt position adjusting bolt.
1. V-belt position adjusting bolt
2. Spacer
V-belt position
More than 1.5 mm
(0.06 in) above the
edge
From 1.5 mm (0.06 in)
above the edge to 0.5
mm (0.02 in) below
the edge
More than 0.5 mm
(0.02 in) below the
edge
Adjustment
Remove spacer
Not necessary (It is
correct.)
Add spacer