Table of Contents
Advertisement
To reset a tripmeter, push the "RESET" button
for at least 1 second while the tripmeter is dis-
played.
NOTE:
To switch the speedometer, odometer, and
G
tripmeter displays between kilometers and
miles, select the odometer mode "ODO",
and then push the "SELECT" button for at
least 10 seconds while the snowmobile is
stopped.
To switch the barometer display between
G
hectopascal "hPa" and inches of mercury
"inHg", select the barometer mode "BARO",
and then push the "SELECT" button for at
least 3 seconds while the snowmobile is
stopped.
Clock
To set the clock:
1.
Push the "SELECT" button and "RESET"
button simultaneously until the hour digits
start flashing.
Control functions
1. "SELECT" button
2. "RESET" button
2.
Push the "RESET" button to change the
hour setting, and then push the "SE-
LECT" button. The minute digits will start
flashing.
3.
Push the "RESET" button to change the
minute setting, and then push the "SE-
LECT" button. The clock starts when the
"SELECT" button is released.
NOTE:
The clock must be set again when the battery
is disconnected.
Display brightness control
This function allows you to adjust the bright-
ness of the meter display to suit the outdoor
lighting conditions.
To adjust the display brightness
1.
Turn the main switch to the off position.
2.
Push and hold down the "SELECT" but-
ton.
13
Advertisement
Table of Contents
