Page 1
2003 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions, please call 1-800-444-3353.
Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes. SKU 45813 PRODUCT SPECIFICATIONS Description SAVE THIS MANUAL...
Do not use a power tool while tired or under the influ- ence of drugs, alcohol, or medication. A moment of inattention while operat- ing power tools may result in serious personal injury. SKU 45813 ELECTRICAL SAFETY PERSONAL SAFETY...
Page 4
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with a sharp cutting edge are less likely to bind and are easier to control. Do not use a damaged tool. Tag damaged tools “Do not use” until repaired. SKU 45813 TOOL USE AND CARE PAGE 4...
Maintain labels and nameplates on the Polisher/Waxer. These carry impor- tant information. If unreadable or missing, contact Harbor Freight Tools for a replacement. Always wear safety impact eye goggles and heavy work gloves when using the Polisher/Waxer.
Page 6
(California Health & Safety Code 25249.5, et seq.) WARNING! People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker. SKU 45813 PAGE 6...
Your tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (See Figure A.) FIGURE A SKU 45813 GROUNDING WARNING! PAGE 7...
(See Figure C.) If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. (See Figure C.) SKU 45813 EXTENSION CORDS PAGE 8...
Page 9
7.1 – 12.0 12.1 – 16.0 16.1 – 20.0 * Based on limiting the line voltage drop FIGURE C to five volts at 150% of the rated amperes. SKU 45813 (120 VOLT) EXTENSION CORD LENGTH Feet Feet SYMBOLOGY Double Insulated...
Page 10
When unpacking, check to make sure all the parts shown on the Parts List on page 14 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Page 11
NOTE: Always start and stop the Polisher/Waxer while it is held firmly against the surface of the vehicle. Failure to do so may result in the Polishing Bonnet (part #29) being thrown from the Pad (part #26). (See Figure D.) SKU 45813 POWER SWITCH (#13)
Remove the Waxing/Polishing Bonnets (part #28, #29) from the Pad (part #26) when the Waxer/Polisher is not in use. This will allow the Pad to dry and retain its original shape. To prolong Pad (part #26) life and shape, store the Waxer/Polisher with the Pad face up. SKU 45813 PAGE 12...
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARIS- ING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACE- MENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 45813 PAGE 13...
Screw Power Cord Holder Power Switch Power Cord Bridge Rectifier NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. SKU 45813 PARTS LIST Qty. Part # Screw Bottom Housing Screw...