Operation - Central Pneumatic HVLP DETAIL SPRAY GUN 46719 Assembly And Operating Instructions Manual

Refer to Assembly Drawing on page 9.
1. To attach the Cup (#13), screw it onto the Material Sleeve (#10).
2. Screw the Regulator (#30) onto the Air Connector (#28).
Warning! Never allow the Spray Gun and Cup (#13) to lay on it's side when the Cup (#13)
is full of paint.
For best service, you should incorporate a
shut-off valve, regulator with pressure gauge,
and filter, as shown. All are available at Harbor
Freight Tools.
Note: It is recommended that you test the
Spray Gun on scrap material, to become
familiar with the available adjustments, prior
to use.
1. Remove the Lid (#14) on the Cup (#13)
and add no more than 5.3 ounces of paint.
Replace the Lid (#14).
2. Connect the air hose to the Regulator
(#30) and set the pressure to 43 PSI. Do
not exceed 43 PSI.
3. Squeeze the Trigger (#15) to test the
pattern.
4. Spray from a distance of approximately four to eight inches while keeping the Spray
Gun perpendicular to the ground.
5. Maintain your distance as you evenly move from side to side. Do not fan or arc the
Spray Gun or the paint will apply unevenly.
6. When you finish spraying, release the Trigger (#15), and disconnect the air hose.
7. Empty the Cup (#13). Never store the Cup (#13) with paint in it.
Warning! Even after the compressor is shut down, the Cup (#13) may still be pressurized.
Open it slowly and carefully.
Adjustments
1. You can fine tune the air pressure by slowly turning the Regulator (#30) and the Air
Adjustment Screw Valve Assy. (#29). You may also adjust the pressure with the air
compressor. Make sure you do not exceed the recommended 43 PSI.
2. You can adjust the amount of fluid coming through the gun with the Fluid Control
3. Knob (#19). Loosen the Fluid Contol Knob Lock (#20), make the adjustment, and
tighten the Fluid Contol Knob Lock (#20).
4. Warning! Keep your hand away from the Trigger (#15) while adjusting jet shape..
5. To adjust the spray pattern, turn the Air Cap (#1).
SKU 46719
Assembly

Operation

Page 5
REV 03e, 09g