Operation - Central Pneumatic 60314 Owner's Manual & Safety Instructions

Delayed or inadequate cleaning will permanently clog the Spray Gun.
Operating Instructions
Read the ENTIRE IMpORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under subheadings therein
before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Workpiece and Work Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
Spray Gun Setup Adjustment
TO pREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained
within this manual. Improper adjustment can result in tool failure or other serious hazards.
CAUTION! Keep hands away from Trigger while making adjustments.
Note: This Spray Gun is meant for spraying
viscous coatings. Do not use with regular
wall paint or thin coatings of any type
as the coverage will not be even.
1. Attach the Hopper to the top of the
Gun Body and tighten the Clamp until
the Hopper is securely in place.
Note: Position the Hopper handle toward
you to spray walls and ceilings; position the
handle away from you to spray floors.
2. Choose the appropriate Nozzle for
the job. Remove the Lock Ring to
change the Nozzle, then replace
and tighten the Lock Ring.
Page 10
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
For technical questions, please call 1-800-444-3353.
2. Route the air hose along a safe
path to reach the work area without
creating a tripping hazard or exposing
the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length
to allow free movement while working.
3. Before spraying, mask nearby
objects not being sprayed and
lay cloths (not included) on the floors.
Note: The larger the Nozzle,
the heavier the pattern.
Coating preparation and Filling
Note: Proper coating mixture is essential.
Most coatings will spray easily if
they are mixed properly.
3. Mix the coating according to
manufacturer's directions.
4. You may have to adjust the mixture
several times until you achieve the
proper consistency. Therefore, do
not fill the Hopper completely until the
proper consistency is achieved.
Item 60314