Advertisement
FIGURE 1
Fluid Cap (1)
Jar Adapter (3)
Jar (6)
Mixing and Thinning Paints
Before attempting to spray any paints through the Spray Gun, dilute them accord-
ing to the manufacturer's directions, for use with Spray Guns.
General Rules:
1.
If mixing colors, only mix together the same types of paints (i.e. lacquer with lacquer
or acrylic with acrylic).
2.
Thin paint according to paint manufacturer's directions. Typically, enamel and lac-
quer paints are diluted with one part thinner to one part paint.
3.
Before spraying make sure the diluted paint is thoroughly mixed.
4.
Mix the paint in a clean jar. We recommend straining the paint before filling the Jar
(6).
Attaching the Air Hose (16) and the jar (6) to the air supply
1.
Fill the Jar (6) with strained paint. Do not fill over 2/3 full.
2.
Carefully thread on the Jar Lid (3).
3.
Attach one end of the Air Hose (16) to the Air Inlet (15) on the Air Brush. Attach the
other end of the Air Hose (16) to the regulator (not included) which then attaches to
the air supply using the 1/4" NPT Adapter (17). The air source must be adjustable
between 15 and 50 PSI. Thoroughly read the instructions and safety warnings
provided with the air compressor and air regulator before using.
For technical questions, please call 1-800-444-3353
SKU 93506
Operation
Lever (9)
Air Tip (7)
Air Hose (16)
Air Valve Connector (15)
Page 4
Advertisement
