Table of Contents
Advertisement
Efficient and easy use of the pressurized pot depends on the careful performance of the
steps required to prepare the pot for use, to fill the pot, and to operate the pot.
Preparing the Pot for Use
1.
Follow the manufacturer's directions when mixing and preparing the paint or coating.
2.
Strain the paint using a fine mesh screen to keep foreign matter and lumps from clog-
ging the pot's passageways.
NOTE: Before using, it is recommended that the air supply line be passed
through a filter to remove any possible dirt, water, or oil from the line.
Filling the Pot
Refer to the parts assembly illustration and the parts list on page 9 while performing the fol-
lowing steps:
1.
Relieve all air pressure in the pot by pulling the ring on the safety valve (9). Pull the ring
until the pressure bleeds down.
2.
Remove the lid assembly by loosening the thumb screws (13) and tipping the lid clamps
back.
3.
Set the lid assembly aside.
4.
Pour the prepared and strained paint into the pot.
5.
Replace the lid assembly (3), and tighten the clamps and thumb screws.
6.
Connect the air supply hose to the air inlet fitting on the pot regulator.
7.
Attach the atomization air hose to the air outlet fitting, which is directly opposite the air
inlet fitting.
Gauge (5)
Adapter, Air Inlet (4)
T-handle Adjusting
Screw
Safety Valve (9)
Yoke Assy
Lid Clamp (14)
SKU 93119
Operation
For technical questions, please call 1-800-444-3353.
Handle (10)
Regulator (6)
Adapter, Air Outlet (4)
Fluid Outlet Adapter (18)
Thumb screw (13)
Page 5
Advertisement
Table of Contents
