Maintenance - Central Pneumatic HVLP DETAIL SPRAY GUN 46719 Assembly And Operating Instructions Manual

Cleaning (Gun should be attached to compressor to complete the cleaning process)
Warning!! Do not use paint strippers on this unit as they will damage the aluminum. Never
allow the unit to lay on it's side while paint is in the Cup (#13).
1. Empty paint from Cup (#13) and add small amount of clean solvent. Replace Lid
(#14) and shake Cup (#13) vigorously. At the lowest possible pressure, spray out the
solvent into a waste bucket (make sure you are wearing respirator and eye protection).
2. Empty Cup (#13) of remaining solvent and repeat the process until the Cup (#13)
solvent appears clean and free of the paint.
3. Disconnect air supply. Remove surplus solvent and wipe the Cup (#13) clean with a
lint free cloth.
4. Note: The Cup (#13) may be fully immersed in solvent for no more than 24 hours if
needed.
5. Remove the Air Cap (#1) and the Fluid Nozzle (#4). Remove the Gasket (#5) and
unscrew the Packing Screw (#6), and remove it. Use the Brush (#12) to clean the
Paint Needle (#22) with solvent. When replacing the Packing Screw (#6), do not over-
tighten. Over-tightening of the Packing Screw (#6) will result in leakage. Unscrew
the Fluid Control Knob Lock (#20) and remove the Fluid Control Knob (#19). Use
the Brush (#12) to clean the gun body opening that the Fluid Control Knob (#19) fits
in, and clean all of the parts.
6. Reassemble gently. Do not force any parts or they will break.
Note: Always dispose of paints and solvents properly. Consult the local hazardous
waste authority for proper disposal procedures and sites.
SKU 46719

Maintenance

Page 7