Teac Pico-1 User Manual page 12

In the following a description of the user controls is given which are
located on the front of the Pico-1.
MASTER drive
The MASTER drive is used to hold the source CD. This may be a pre-
recorded audio CD or CD-ROM which you have permission to copy, or
a CD-R disc. The eject button is used to eject the master disc when no
operation is in progress. The indicator on this drive shows when the
disc is being accessed. In the "Play audio" mode (see
Track"), a prerecorded CD may be inserted into this drive, and played
back, track by track.
SLAVE drive
The SLAVE drive holds the destination CD. This must be a CD-R or
CD-RW disc. The eject button is used to eject the slave disc when no
operation is in progress. The indicator on this drive shows when the
disc is being accessed for reading or writing.
NOTE
If a disc is in a drive and cannot be removed by using the eject
button, you can insert a thin stiff wire (such as the end of a
paperclip) into the hole on the front panel of the drive (under
the tray). This will open the tray.
44
3.5 "Play Audio
2. General Description