Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Teac Pico-1
Summary of Contents for Teac Pico-1
- Page 1 To ensure the smooth handling of your warranty please write the serial number of your device into the box. In the case of warranty you are expected to send it to- gether with a copy of your invoice to your nearest TEAC sales representative.
- Page 2 • Changes in specifications and features may be made with- out notice or obligation. • Copyright © 2002, TEAC Deutschland GmbH. All rights re- served. First edition: March 2002 • Company and product names provided herein are trade- marks of their respective companies.
-
Page 3: Table Of Contents
For the Consumers in Europe ............ 37 1. IMPORTANT SAFETY INSTRUCTIONS ........38 2. GENERAL DESCRIPTION ............41 2.1 Installing the Pico-1 .............. 42 2.2 Components of the Pico-1 ........... 42 2.3 Basic Operations ..............45 3. MODES ..................47 3.1 Disc Copy ................47 3.2 Test Write Mode.............. -
Page 4: Introduction
The stand-alone CD Copy Station reproduces CDs without the neces- sity for a PC, additional software packages, or any kind of adapter cards. It is equipped with one TEAC IDE Writer and an IDE CD-ROM drive, and so can copy CDs quickly and without any problems – the data are simply read by the CD-ROM. -
Page 5: Important (For U.s.a. Customers)
CAUTION Changes or modifications to this equipment not expressly approved by TEAC Deutschland GmbH for compliance could void the users authority to operate this equipment. For the Consumers in Europe WARNING This is a Class A product in a domestic environment. -
Page 6: Important Safety Instructions
1. IMPORTANT SAFETY INSTRUCTIONS CAUTION: – Read all of these instructions. – Save these Instructions for later use. – Follow all warnings and instructions later on the audio equip- ment. 1) Read Instructions – All the safety and operating instructions should be read before the product is operated. - Page 7 10) Ventilation – Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to pro- tect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similiar surface.
- Page 8 17) Servicing – Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 18) Damage Requiring Service – Unplug this product from the wall outlet and refer servicing to qualified service personnel under the fol- lowing conditions: a) When the power supply cord or plug is damaged.
-
Page 9: General Description
It it es- pecially useful for duplicating material produced using the TEAC CD Writer series on CD-R media. The Pico-1 can also be used to duplicate CD-ROM material of which you own copyright or for which you have appropriate permission. -
Page 10: Installing The Pico-1
CD-R discs using the Pico-1 which may not be im- mediately obvious. 2.1 Installing the Pico-1 There are no connections to be made to and from the Pico-1 other than the power connection on the rear Panel, as the unit is completely self-contained. - Page 11 In the following a description of the user controls is given which are located on top of the Pico-1. MODE ENTER Display The 2 x 16 LCD display displays the menus and submenus available, and also provides information on the status of the current operation, as well as displaying error messages, etc.
- Page 12 In the following a description of the user controls is given which are located on the front of the Pico-1. MASTER drive The MASTER drive is used to hold the source CD. This may be a pre- recorded audio CD or CD-ROM which you have permission to copy, or a CD-R disc.
-
Page 13: Basic Operations
NOTE Do not turn off the Pico-1 while writing to the slave disc (i.e., part of the way through a disc copy operation). If you do, the disc will be corrupt, and unusable. - Page 14 CD-R disc, read the precautions supplied with the disc, or contact the disc manufacturer directly. 2.3.5 Discs recommended for use with the Pico-1 The best results and the highest performance are ensured when using TEAC write-once CD-R media respectively CD-RW Media.
-
Page 15: Modes
CD-R/CD-RW disc useless for any purpose. Do not use warped discs or discs with off-center holes with the Pico- 1. While the copy operation is in progress, make sure that the Pico-1 is not subjected to vibration or mechanical shocks. 3. Modes... - Page 16 Error, ## TRAY Open ## the trays and continue with pressing the MODE or ENTER keys. Start the copying process again. The Pico-1 will read the master CD and it checks the CD-R respectively the CD-RW inserted in the slave drive (Checking Media, Cheching Data).
- Page 17 CD-RW disk The copying will be resumed after approx. 30 seconds. If the Pico-1 does not detect any potential problems with the discs it will write the TOC information onto the slave CDs. The screen contains the following message during this process:...
-
Page 18: Test Write Mode
Continue? ENTER is used to accept while with MODE the test is skipped. At the beginning of the test the Pico-1 simulates writing the TOC information. The display shows the same messages, under the same circumstances, except that the word Copy... -
Page 19: Possible Problems When Copying Or In Test Write Mode
At the end the following is shown: Test write Test write Test write Test write Test write Complete Complete Complete Complete Complete NOTE There is one other important difference between test write mode and copy mode. You can interrupt the test write mode part of the way through the operation without affecting the slave CD-R/CD-RW media. - Page 20 The message above will also be shown if the slave disc is of a smaller capacity than the source disc. In these instances, it is impossible to copy from the master to the slave disc. If the master disc is scratched, damaged or unreadable for any reason, the copy process will halt, and the display will appear as below.
-
Page 21: Compare Cd-Rom
3.4 Compare CD-ROM This mode is used for comparing CD-ROM which has just been dupli- cated using the copy mode. It cannot be used for audio CDs (Mes- sage: Audio compare is not supported). Press the MODE key until the display shows the following: Mode select Mode select Mode select... - Page 22 If there has been an error on the copying (i.e. the two CD-ROMs do not match) or if they do not match in any other way (the wrong pair of discs has been loaded), the compare operation will stop at the point at which the mismatch was detected, and the display will show: Compare CD-ROM...
-
Page 23: Play Audio Track
„audition“ a CD copy. Plug audio equipment like an amplifier to the audio connectors at the rear of the Pico-1. Insert the CD to test into the master drive. Press the MODE key until the display shows the following:... - Page 24 Pressing the MODE key from the display shown above will change the display again: Track 05 Play Track 05 Play Track 05 Play Track 05 Play Track 05 Play 3 Exit 3 Exit 3 Exit 3 Exit 3 Exit Press the ENTER key from this screen to exit the audio play mode and return to the main mode selection screen.
-
Page 25: Setting The Writing Speed
3.6 Setting the Writing Speed The Pico-1 SLAVE drive is capable of writing information to a CD or CD-ROM drive at double (2X), four times (4X) or eight times (8X) nor- mal speed. The writing speed is set as described below. Once the speed is selected, it is used in the CD copying and testing modes. -
Page 26: Individually Arranging An Audio Cd
3.7 Individually Arranging an Audio CD This mode allows to collect songs of one or more audio CDs and to produce an individually music CD of your own. Insert the respective audio CD into the master drive an an empty CD- R or CD-RW into the slave drive. - Page 27 If you reached the end of the menu this message appears: [Select [Select [Select [Select] #01 [Select Select Next Select Next Select Next Select Next Select Next By pressing ENTER you are able to select the next song of the CD inserted in the master drive.
- Page 28 3.7.3 Copying the selected Titles to a CD If you finished the list (otherwise you are able to make a new one) you have to enter the write mode. To achieve this you have to oper- ate the MODE key as long as you can see this screen: Make favorite Make favorite Make favorite...
- Page 29 3.7.6 Errors and miscellaneous Messages The message No disc No disc is displayed together with master or slave if No disc No disc No disc wether in the master nor in the slave drive a CD is inserted. If the master drive does not contain an audio CD the message Error Error Error Error...
-
Page 30: Specification
4. SPECIFICATION CD-ROM: TEAC CD-W28E Performance 24x read CD-Writer: TEAC CD-W28E Performance 24x read/8x write/8xrewrite Drive performance Access time 110ms (average) Transfer Rate 3.6MB/s read 1.2MB/s write - 1.2MB/s rewrite Buffer size Compatibility CD-ROM Mode1, CD-ROM Mode2, Enhanced-CD, CD-ROM-XA Mode2, CD-DA, Photo-CD, CD-RW... -
Page 31: Technical Support
5. TECHNICAL SUPPORT In case the TEAC Pico-1 does not operate normally in the environment specified in this manual, contact the representative from whom you purchased the drive or our nearest sales office to you. Technical Service Depots (Europe) TEAC Deutschland GmbH, DSPD (Germany) Technical Support Tel: 0180 5 999 588 (EUR 0.12/min (Germany)) - Page 32 TEAC Service Centre Poland Ul. Osiedlowa 31 68-114 Tomaszowo Technical Support Tel: +48 (0) 68 36 06 300 Mo-Fr from 9:00 – 16:00 CET Technical Support Fax: +48 (0) 68 36 06 309 Online RMA: http://www.teac.de/RMA Internet: http://www.teac.de/support Contact us by email: support_pl@ja.teac.de...
-
Page 33: Warranty
According to the following terms this TEAC product will be repaired without charge of labor and materials by the authorized TEAC service stations, by the authorized TEAC dealers and/or their authorized service stations. TEAC,... - Page 34 TEAC; (d) repair or attempted repair by anyone not authorized by TEAC to repair this product; (e) causes other than product defects, including lack of technical skill, competence or experience of the user.
- Page 35 No one is authorized to assume any greater liabil- ity on TEACs behalf. TEAC shall not be liable for any damage to any other properties independant of their virtual or real nature espe- cially there is no liability for any damage to any kind of software and/or any kind of databases caused by TEAC products.Furthermore...
- Page 36 TEAC Deutschland GmbH, DSPD: Bahnstraße 12, 65205 Wiesbaden-Erbenheim, Germany Internet: www.teac.de TEAC UK LIMITED DATA STORAGE PRODUCTS DIVISION: 5 Marlin House, Marlin Meadow, Croxely Business Park, Watford, Hertfordshire, WD18 8TE, U.K. TEAC FRANCE S.A.
- Page 37 Dauer der Gewährleistung Welche Kosten werden übernommen TEAC Deutschland GmbH, nachfolgend TEAC genannt, gewährt dem Erstkäufer für dieses Produkt ab dem Datum des Kaufs TEAC übernimmt die Kosten für die im Rahmen einer Garantiereparatur anfallende Arbeitszeit und die Materialien, die zwei (2) Jahre Garantie bezüglich jedes etwaigen Defekts an Material und Herstellung.
- Page 38 DSPD Bahnstraße 12 65205 Wiesbaden-Erbenheim Germany TEAC Deutschland GmbH, DSPD: TEAC UK LIMITED DATA STORAGE PRODUCTS DIVISION: Bahnstraße 12, 65205 Wiesbaden-Erbenheim, Germany 5 Marlin House, Marlin Meadow, Croxely Business Park, Internet: www.teac.de Watford, Hertfordshire, WD18 8TE, U. K. TEAC FRANCE S.A.