The picture cannot be recorded.
•
Is the [REC]/[PLAYBACK] selector switch at the [!] setting?
•
Is the mode dial correctly set?
•
Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory.
The recorded picture is whitish.
•
The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> If the lens is dirty, turn the camera off, retract the lens barrel
surface with a soft dry cloth.
The area around where the pictures were taken becomes dark.
•
Was this picture taken with the flash at the close range when the zoom is near [W] (1k)?
> Zoom in a little, and then take the pictures.
> Is this a picture taken in [PIN HOLE] in Scene Mode?
The recorded picture is too bright or dark.
> Check that the exposure is correctly compensated.
•
Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
> Set the [MIN. SHTR SPEED]
2 or 3 pictures are taken at one time.
> Set Auto Bracket (P76), Colour Bracket (P77), [HI-SPEED BURST], [FLASH BURST] in
Scene Mode (P100, 101), or the Burst Mode
•
Is the self-timer
(P73)
The subject is not focused properly.
•
The focus range varies depending on the Recording Mode.
> Set to the proper mode for the distance to the subject.
•
The subject is beyond the focus range of the camera.
•
There is camera shake (jitter) or the subject is moving slightly.
Recording
(P143)
to slower speed.
set to [10S/3PICTURES]?
- 205 -
Others
(P26)
(P10)
(P52)
(P75)
(P78)
to [OFF].
(P48)
(P50)
(P58)
and gently wipe the lens