Panasonic LUMIX DMC-FZ38 Operating Instructions Manual page 17

∫ Charging
Charging time
•
The indicated charging time is for when the battery has been discharged completely.
The charging time may vary depending on how the battery has been used. The charging
time for the battery in hot/cold environments or a battery that has not been used for long
time may be longer than normal.
When the charging has been completed successfully, the [CHARGE] indicator turns off.
Charging time and number of recordable pictures with the optional battery pack are the
same as above.
∫ When the [CHARGE] indicator flashes
•
The battery temperature is too high or too low. Please charge the battery again in a
temperature between 10 oC to 35 oC (50 oF to 95 oF).
•
The battery has not been used for a long time (and is completely discharged). The [CHARGE]
indicator will light up after a short period, and the battery will charge normally. Leave the battery
to charge as normal.
•
The terminals of the charger or the battery are dirty. In this case, wipe them with a dry cloth.
∫ Battery indication
The battery indication is displayed on the LCD monitor/Viewfinder.
[It does not appear when you use the camera with the AC adaptor (optional) connected.]
•
The indication turns red and blinks if the remaining battery power is exhausted. (The power
lamp also blinks) Recharge the battery or replace it with a fully charged battery.
Note
•
After charging is completed, be sure to disconnect the power supply device from the electrical
outlet.
•
The battery may be warm after use, during charging, immediately after charging etc. The
camera also becomes warm during use. This is not a malfunction.
•
The battery will become discharged if left for a long period of time after being charged.
•
The battery can be recharged even when it still has some charge left, but it is not
recommended that the battery charge be frequently topped up while the battery is fully
charged. (Since characteristic swelling may occur.)
•
Do not leave any metal items (such as clips) near the contact areas of the power plug.
Otherwise, a fire and/or electric shocks may be caused by short-circuiting or the
resulting heat generated.
Preparation
Approx. 120 min
- 17 -