Set Up; Initial Test Run - Central Machinery 93212 Set Up And Operating Instructions Manual

set uP

initial test run

Before further set-up of the Lathe, check
that the power components are working
properly by performing the following test
run.
1. Check that all loose parts and tools are
out of the way and nothing will interfere
with the Chuck (2) when it rotates.
Nuts (6)
Figure 10
2. Turn the Chuck by hand and check that it
rotates freely.
3. Check that the three Nuts (6) on the
Chuck are tight.
Feeding Direction Selector (35)
H/L Gear Shift Lever (33)
Figure 11
4. On the back of the Lathe, set the H/L
Gear Shift Lever (33) to low and the
Page 14
Chuck (2)
Spindle (3)
For technical questions, please call 1-800-444-3353.
Feeding Direction Selector (35) to the
middle (Neutral).
Forward/OFF/Reverse Switch (181)
Fuse Holder (179)
Power Switch (178)
Figure 12
5. On the front of the Lathe,
Forward/OFF/Reverse Switch (181) is
set to the OFF position.
6. Turn the Speed Control Knob (180) to
zero.
Warning: BeFore turning on the
Mini Lathe each tiMe it is to Be
used, the sPeed controL knoB
(180) Must Be set to zero.
7. Plug in the electrical cord and turn
the Forward/OFF/Reverse Switch to
Forward.
8. Turn the Power Switch (178) to the ON
position.
9. Gently rotate the Speed Control Knob
clockwise past the 1 to the first setting.
The speed will increase the further the
Knob is turned. The Lathe should run
smoothly with little or no vibration or
friction sounds when it starts. If you
notice unusual sounds or vibrations, turn
off the Power Switch, turn the Speed
Control Knob to 0, unplug the machine
and have the problem corrected before
further use.
10. If the Lathe is running smoothly, continue
running it for several minutes, gradually
increasing the Speed Control Knob
Speed Control Knob (180)
make sure the
SKU 93212
reV 10b