Assembly Instructions; Attaching Rubber Feet Or Installing To Workbench; Installing Handwheel Handles - Central Machinery 93212 Set Up And Operating Instructions Manual

asseMBLY instructions

note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
1. Warning! Make sure the Power
Switch of the tool is in its "OFF" position
and that the tool is unplugged from
its electrical outlet before making any
adjustments to the tool.
2. Clean off the protective grease on the
Mini Lathe.
attaching rubber Feet or
installing to Workbench
note: Mount or place the Lathe on a sturdy
workbench or table, with good lighting,
at a height that allows you to comfortably
work without back strain.
The Lathe can be mounted permanently
to a workbench or used with it's included
Rubber Feet (125) on a tabletop.
to attach the rubber Feet:
Chip Tray (126)
Rubber Feet (125)
Figure 4
To attach the Rubber Feet to the bottom
of the Lathe, unthread the Bolts (67)
from the bottom of the Chip Tray (126).
Slide the Rubber Feet onto the Bolts
and re-thread them into the bottom of
the Lathe through the Chip Tray holes.
Tighten securely.
Page 12
Bolts (67)
Bolts (67)
For technical questions, please call 1-800-444-3353.
to Mount the Lathe to a Workbench:
Drill holes for permanent mounting:
Figure 5
Unthread the Bolts (67) from the bottom
of the unit. Measure and drill holes in the
workbench. Use appropriate length M6-1
bolts and washers (sold separately) to
secure the Lathe and Chip Tray to the
workbench.

installing handwheel handles

Tailstock Quill Control Wheel (84a)
Cross Slide
Crank (86a)
Feed Control Wheel (84b)
Figure 6
1. To install the Handwheel Handles on the
Tailstock Quill Control Wheel (84a) and
the Feed Control Wheel (84b), use a
flathead screwdriver and a 14mm open
end wrench to thread the handles onto
the wheels.
2. For packaging purposes, the Cross Slide
Crank (86a) is shipped from the factory
facing backwards. Adjust the Cross Slide
Crank (86a) to face forward using a 5mm
Hex Wrench (part of 311) to unthread the
Cap Screw (52) and turn the Cross Slide
Crank around. Tighten the Cap Screw
securely.
14-7/8"
Handwheel Handles
SKU 93212
reV 10b