Before Recording (Deck 2 Only); Tape-To-Tape Recording - Panasonic SC-AK48 Operating Instructions Manual

A
Recording part
TUNE TIME ADJ
1
2
4
TUNE MODE
1
TAPE
DECK 1/2
2
DECK 1
OPEN
3
REV MODE
4
TAPE EDIT
20
RQT5321
Leader tape
(no recording can be made)
aREC/STOP
DECK 2
OPEN
Tape direction of the tape you
are recording onto

Before recording (Deck 2 only)

Types of tapes which can be recorded correctly
The unit automatically identifies the type of tape.
NORMAL POSITION/TYPE I
HIGH POSITION/TYPE II
METAL POSITION/TYPE IV
Metal position tapes can be used, but the unit will not be able to
record or erase them correctly.
Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast material may infringe
copyright laws.
To record from the beginning of the tape A
You cannot record on the leader part of the tape. Before recording,
wind the tape past the leader to a point where recording can start
immediately.
How volume, sound quality/field affect recording
The tape you are recording is not affected whatsoever by changes in
volume, sound quality/field.
To erase a recorded sound
2
1. Press [TAPE, DECK 1/2].
2. Insert the recorded tape into deck 2.
3
3. Press [REV MODE] to select reverse mode.
4. Press [a REC/STOP].
Notes
•
You cannot open deck 1 while recording.
•
You cannot fast-forward or rewind one deck while recording with
the other.

Tape-to-tape recording

The recording level will be recorded as it is on the tape being played
back.
Press [TAPE, DECK 1/2].
1
Press [c OPEN] on both decks and insert the tapes.
2
For playback: Into deck 1
For recording: Into deck 2
Close the holders by hand.
Tape direction is automatically set to " 3".
Press [REV MODE] to select the reverse mode.
3
Every time you press the button:
: One side is recorded, then recording stops auto-
matically.
: Both sides (front side
,
then recording stops automatically.
Press [TAPE EDIT] to start recording.
4
•
If you selected "
automatically change to "
To stop recording
Press [L].
Both decks will stop.
To start recording on the reverse side
Load a tape and change the tape direction as follows:
1. Press [TAPE, DECK 1/2] and select tape deck 2.
2. Press [/] and immediately thereafter [L]. The tape direction will
be shown as "4".
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
reverse side) are recorded,
" in step 3, the direction will
" when recording starts.