Presetting Radio Broadcasts - Panasonic SC-AK48 Operating Instructions Manual

1
2
3
1
TUNER
BAND
2
TUNE MODE
3
TUNE TIME ADJ
4
MEMORY
4
TUNE TIME ADJ
Preset channel

Presetting radio broadcasts

•
Up to 12 stations can be set in each band with the automatic or
manual memory presetting.
•
If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
•
You can preset just those stations you like. (See "Presetting only
your favourite stations" below.)
Press [TUNER, BAND] to select band.
1
The unit will come on automatically.
Every time you press the button: FM
Press [L L L L L , TUNE MODE] to select "MANUAL".
2
Every time you press the button: MANUAL
Press [TUNE/TIME ADJ (3) or (4)] until the display
3
shows the frequency from which you want to begin
automatic memory presetting.
Tips on tuning in radio stations
1 Hold down either arrow button until the frequency numbers
start scrolling.
2 When near to the frequency you are looking for, press the
button repeatedly until the station is tuned in.
) /f ) ) )
Press and hold [)
4
frequency begins to change.
This will start presetting automatically. When finished, the radio
will tune in the last station memorized.
If auto presetting is not possible because radio signals are weak
or for some other reasons, do the following.
Presetting only your favourite stations
Preset the stations one at a time.
1. Perform step 1 above. Then, press [)/f, MEMORY]
("MEMO" flashes) and select a station with [TUNE/TIME ADJ
(1 1 1 1 1 ) or (2 2 2 2 2 )].
2. While "MEMO" is flashing, press [)/f, MEMORY] again and
select a preset channel with [TUNE/TIME ADJ (1 1 1 1 1 ) or (2 2 2 2 2 )].
3. Press [)/f, MEMORY] to preset the station.
Memory retention
Your preset is retained in memory for about 2 weeks while the system
is unplugged.
AM
PRESET
f f f , MEMORY] until the f
11
RQT5321