Timer Recording - Panasonic NV-VP33 Operating Instructions Manual

Timer recording

Timer recording Timer recording
Pos Pos Date Date Start Stop Start Stop
1 ARD 31/12 10:30 11:30 SP ON 1 ARD 31/12 10:30 11:30 SP ON
1 ARD 31/12 11:30 12:30 SP ON 1 ARD 31/12 11:30 12:30 SP ON
2 ZDF 31/12 12:30 13:30 SP ON 2 ZDF 31/12 12:30 13:30 SP ON
4 RTL 31/12 13:30 14:30 SP ON 4 RTL 31/12 13:30 14:30 SP ON
6 VOX 31/12 14:30 15:30 SP ON 6 VOX 31/12 14:30 15:30 SP ON
-- - - - - - -/ - - - -:- - - -:- - SP - - - -- - - - - - -/ - - - -:- - - -:- - SP - - -
: ENTER ENTER :
:select select : store store
CANCEL CANCEL : EXIT EXIT :
: delete delete exit : exit
20
The Timer recording allows you to programme the recording time of TV programmes
up to 1 month in advance. Use the on-screen menu to programme a maximum of 16
recordings.
PROG/CHECK
Press PROG/CHECK and select a free storage position
1 / 3 1 / 3
Confirm with ENTER.
VPS VPS
PDC PDC
Select a station
Then enter start and stop time
Hold buttons down to change time in 30-minute steps.
Select tape speed: A (Automatic), SP, LP, EP
The VPS/PDC settings may be changed with
Press ENTER to save timer programme.
Repeat these steps for further recordings you may wish to programme.
Press TIMER to activate the VCR´s timer mode.
Make sure the VCR symbol
also lights up if the function was not turned off.
The Timer Rec button blinks for 5 seconds if the timer is turned on and you try to
perform a function. Most buttons are blocked when the timer is turned on.
Do not forget to verify that there is enough tape left. The length of the recording
must not exceed the tape left on the video cassette.
Quitting the timer mode
Press TIMER. The VCR symbol
You can now play back a cassette or make a manual recording. Press TIMER
again to reactivate the previously entered timer programme.
, and use to set date, week or weekday
, .
is displayed. The Timer Rec button on the device
will turn off.
.
.
, .
(does not apply to VP23).