Setup Menus - Panasonic NV-VP33 Operating Instructions Manual

SETUP menus

Dolby Digital / DTS Digital
Surround / MPEG:
Please choose the correct settings
matching your audio system:
Your equipment Your equipment
can not decode can decode the
the signal signal
Dolby
PCM Bitstream
Digital
DTS Digital
PCM Bitstream
Surround
MPEG
PCM Bitstream
Menu Audio
PCM Digital Output
Dolby Digital
DTS Digital Surround
MPEG
Dynamic Range Compression
Menu Display
Menu Language
On-Screen Messages
Menu Others
QUICK SETUP
Re-initialise Setting
PCM is the standard method used to record digital music signals on Audio CDs. For
reasons of copyright protection the digital output of PCM audio signals may be limited
to 48 kHz/16 bit. Choose [Up to 48 kHz] if the digital audio outlet is used to connect
your player to an amplifier that only processes sampling frequencies of up to 48 kHz.
For 96 kHz check the digital-in requirements of your connected device.
Change the setting to PCM if the connected equipment fails to decode the relevant
signal. High noise levels may otherwise damage your ears or the loudspeakers.
Adapt the settings to the ratings of your audio system.
Available in the Dolby Digital (DVD) format only.
The volume range is compressed by dynamically putting up the level of
soft passages and lowering the level of loud passages.
Select the language of the appliance's menus as appropriate.
Select [Off] to suppress the display of OSD text.
Lets you change the basic settings or your appliance.
Resets the appliance to factory defaults. Following reset and initialisation,
press SETUP to run the QUICK SETUP utility again.
28
28
41