Tape-To-Tape Recording; Using The Built-In Sound Quality Settings; Enhancing The Sound Quality - Panasonic SC-AK300 Operating Instructions Manual

A
2
1
1
DECK 1
OPEN
2
REC
B
PRESET EQ
C
22
RQT6131
PRESET EQ
PRESET EQ
SUPER
SOUND EQ
S. SOUND EQ

Tape-to-tape recording

A
The recording level will be recorded as it is on the tape being played
back.
Preparations:
•
Do the preparatory steps (A page 20).
•
Press [TAPE :] then [L/–DEMO] to select tape as the source.
1
Press [c DECK 1 OPEN] and insert the
tape you want to record.
2
Press [a a a a a REC] to start recording.
To stop recording
Press [L/–DEMO].
Both decks will stop.
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
Using the built-in sound quality
B
settings
Press [PRESET EQ] to select the sound
quality.
Every time you press the button:
HEAVY SOFT CLEAR
EQ-OFF
HEAVY : Select this when playing rock or other kinds of music that
sounds better with an added punch.
SOFT : Select this when listening to background music.
CLEAR : Select this for jazz or other kinds of music for which clarity
in the treble range is desired.
VOCAL : Select this to add gloss to vocals.
The original display is restored on the display panel in about 4 seconds.
Notes
•
Preset EQ cannot be used together with Super Sound EQ.
•
All recordings are performed at "EQ-OFF" setting even if an
alternative sound quality setting has been selected.

Enhancing the sound quality

C
This feature enhances the bass and treble effect of the sound.
Press [SUPER SOUND EQ].
Remote control: Press [S.SOUND EQ].
Press the button again to cancel.
The button light goes out.
VOCAL