Maintenance And Servicing; Troubleshooting - Chicago Electric 66098 Set Up And Operating Instructions Manual

Maintenance and
Servicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FrOM accidental
OperatiOn:
turn the power Switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
tO prevent SeriOuS
injury FrOM tOOl
Failure:
do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
cleaning, Maintenance, and
lubrication
1. BeFOre eacH uSe, inspect the
general condition of the tool. Check
problem
Heat Gun will not turn
on.
Unsatisfactory results. 1. Improper heat setting.
SKU 66098 For technical questions, please call 1-800-444-3353.
tO prevent
SeriOuS injury

troubleshooting

possible causes
1. Power Switch set at "0".
2. No power at outlet.
3. Cord not connected.
for loose screws, cracked or broken
parts, damaged electrical wiring, and
any other condition that may affect its
safe operation.
2. aFter uSe, clean external surfaces
of the tool with clean cloth.
3. Warning! if the supply cord of
this power tool is damaged, it must
be replaced only by a qualified
service technician.
pleaSe read tHe FOllOWing careFully
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION
OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS qUALIFIED TO MAKE ANY
REPAIRS TO THE PRODUCT, OR THAT HE OR
SHE IS qUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR ExPRESSLY STATES
THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND
LIABILITY ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS
THERETO.
possible Solutions
1. Turn Power Switch to "l" or "ll".
2. Check power at outlet.
3. Check that cord is plugged in.
1. Adjust heat setting ("l" or "ll") for
correct application.
Page 11