General Operating Procedures; Maintenance And Servicing; Inspection, Maintenance, And Cleaning - Chicago Electric 96289 Set Up And Operating Instructions Manual

1. Make sure the Power Switch (3) is in its
er Cord (1) of the tool into the nearest 120 volt, grounded, electrical outlet.
(See Figure A, previous page.)
2. To turn on the Heat Gun, set its Power Switch (3) to
• Switch "l" -
for mild heating applications, i.e., heat shrink tube, heat shrink bag, plastic
bending, shaping and welding, removing old paint coating. (See Figure A.)
• Switch "ll"
intense heating applications, i.e., frozen water pipe, defrosting refrigerator, and
metal welding. (See Figure A.)
3. To turn off the Heat Gun, set its Power Switch (3) to
Switch to "0" and unplug the tool from its electrical outlet. (This method helps
cool down the Heat element (11) properly to extend the life of the Heat Gun.)
(See Figure A.)
4. CAUTION! danger of fire.
surface until it has completely cooled.
5. Once cooled, store the Heat Gun in a clean, dry, safe location out of reach of
children and other unauthorized people.
WARNING
1. dISCONNECT from power outlet and make sure that it is completely cooled.
2. BEFORE EACH USE,
for loose screws, misalignment or binding of moving parts, cracked or broken
parts, damaged electrical wiring, and any other condition that may affect its safe
operation.
SKU 96289 For technical questions, please call 1-800-444-3353.

General Operating procedures

Low temperature position (572° Fahrenheit maximum). Used
- High temperature position (1076° Fahrenheit maximum). Used for
Make sure to set the Heat Gun on a non-flammable

MAINTENANCE ANd SERVICING

Risk of serious personal injury from accidental starting
or electric shock. Turn the power Switch of the tool to its
"OFF" position and unplug the tool from its electrical outlet
and allow the tool to completely cool before performing any
inspection, maintenance, or cleaning procedures.
damaged equipment can fail, causing serious personal
injury. do not use damaged equipment. If abnormal noise or
vibration occurs, have the problem corrected before further
use.

Inspection, Maintenance, and Cleaning

inspect the general condition of the Heat Gun. Check
"0" (OFF) position. Then plug the Pow-
"l" or "ll".(See Figure A.)
"l". Then set the Power
ReV 08b
Page 12