Touch Control System; Fluid Level; Draining And Filling The Reservoir - International Harvester Company CUB Operator's Manual

LUBRICA TION
Never operate the tractor without having
sufficient fluid in the reservoir. Insufficient
fluid may cause damage to the Touch-Control
system.
OIL FILTER -Continued
Changing the Filter Element -Continued
Note: Failures due to use of improper
fluid are not covered by warranty --FOR
MAXIMUM PROTECTION USE IH HY-TRAN
FLUID.
8. To install the new filter element, move
gasket "C" up to the top of bolt "B" and place
cover "A", gasket liD" and the new element
on the bolt in their proper order. See Illust. 62.
Then install the entire assembly and be sure
that filter cover gasket "D" seats properly.
Screw the bolt into the filter base and tighten
securely.
Draining and Filling the Reservoir
Normally it is not necessary to drain the
reservoir at any given time interval. If it be-
comes necessary to drain the system for any
reason. such as disassembly, flushing the
system, etc.. proceed as follows:
9. Check the oil level in the crankcase to
see that the new oil is up to the proper level
(see "Lubrication Guide"). Now start up the
engine, check the oil pressure gauge to see
whether lubricating oil is circulating through
the engine, and inspect the filter for oil leaks. 1. Wipe off all dirt and grit from the reser-
voir and filler plug.
TOUCH CONTROL SYSTEM
2. Remove the filler plug (1IIust. 13) and the
drain plug (1IIust. 63) and place them in a clean
container. Fluid Level
When the Touch- Control system is filled
to the proper level with IH Hy- Tran @ Fluid, it
should not require servicing, unless for some
reason the system has been disturbed.
When the fluid has stopped draining. run
the engine very briefly to drain the fluid from
the pump and connecting pipes.
To clean the strainer, first wipe off all dirt
and grit from the cylinder block. H your trac-
tor is equipped with a radiator shutter, dis-
connect the radiator shutter control rod. Then
remove the heat indicator element from the
strainer by screwing out the element nut.
H the Touch-Control system should fail to
operate in a satisfactory manner, check to
see if there are any noticeable leaks in the
system, also check the fluid level in the res-
ervoir, or see your hlternational Harvester
dealer.
Before removing the filler plug (1IIust. 13)
for inspection. thoroughly clean the plug and
surrounding area of all dirt and grit.
The correct fluid level is to the bottom of
the filler opening. H it is necessary to add
fluid, use ill Hy-Tran Fluid. It is essential
that the fluid be absolutely clean and free from
water and all foreign matter when placed in the
system. Cloudiness may indicate the presence
of moisture.
II lust. 63
Right side of Touch-Control system.
63