Changing The Filter Element - International Harvester Company CUB Operator's Manual

LUBRICA TION
OIL FILTER. Continued
Ii the element is not serviced and becomes
clogged, the element by-pass valve will open
and wrliltered oil will be circulated throughthe
engine.
3. Unscrew and remove bolt "B" and gasket
"G" (1!lust. 62).
4. Lift up and remove filter cover "A" and
gasket "D" (1IIust.62).
Note: To avoid delays, carry extra filter
elements on hand so replacement can be made
at the proper time.
5.
Remove the old element.
6. H the oil appears very dirty or sludgy
when draining. flush out the filter case withkerosene.
Before flushing. however. replace
the bolt without the filter cover in order to
prevent sludge from being flushed into the
crankcase. When completely flushed and
drained. replace the drain pipe cap.
Changing the Fi Iter Element
Do not change the element while the engineis
running.
1. Remove the oil filter drain pipe cap
(1IIust.62A) and allow the oil filter to drain
completely.
7. Inspect the small metering hole at the
threaded end of the oil filter retainer bolt, and
make sure it is not plugged. A plugged meter-
ing hole will impair or stop all oil flow through
the oil filter element.
2. Clean off filter cover I'A'I (1IIust.62) to
prevent dirt from dropping into the filter when
the cover is removed.
Illust. 62
Diagram of 011 flow through the filter.
Illust.62A
Installing the new oil filter element.
62