Transmission, Belt Pulley And Power Take-Off - International Harvester Company CUB Operator's Manual

TROUBLE SHOOTING
Possible Remedy
Possible Couse
IGNITION AND ELECTRICAL. Continued
Battery defective, low charge or loose
connections. Recharge, clean and tighten the cable lugs or
replace with new; check the ground cable; see
pages 33 and 34.
Cranking motor failure. Replace. *
Generator
inoperative. Clean the commutator, check the brushes; see
page 32.
Voltage
regulator or generator relay. *
Charge indicator inoperative. Replace the charge indicator. *
Charge indicator shows discharge. Check the battery and generator; check the drive
belts and wiring.
Lights will not burn. Check the battery ground cable. Turn on the
switch, replace the sealed beam units, replace
the fuse, recharge the battery, or check the
wiring and generator. *
Lights burn dim. Turn the switch to bright. Recharge the battery,
tighten the cable terminals, check the sealed
beam units, clean the contacts.
BRAKES
Do not hold. Adjust the brakes; see pages 51 and 52 for new lining
needed. *
Drag or uneven. Adjust the brakes; see pages 51 and 52.
Grease on lining. Replace the lining. *
Return spring broken. Replace.
Do not release. Release the brake lock. Be sure the left brake
cross shaft is free to turn.
TRANSMISSION, BELT PULLEY AND POWER TAKE.OFF
Hard to shift gears. Use lubricant of the correct viscosity; see
page 65.
Shifter fork or lever defective. Replace. *
Engine clutch drags. See "Lack of Power. II
Gears
clashing. Stop the tractor and disengage the clutch before
shifting the gears.
Gears slipping out of mesh. *
Noisy. Check the oil level; use lubricant of the proper
viscosity. *
Damagedparts *
REAR WHEELS
Do
not turn. Release the brake lock. Transmission, differen-
tial or clutch faulty. See the transmission
section above. *
FRONT WHEELS
Too tight or toQ loose. Check the lubricant in the bearings, check the
bearing adjustment; see page 64.
Lubricant leakage. Check the oil seal. *
>'" See your International Harvester dealer.
59