Setting The Channels And Clock - Panasonic Diga DMR-EX98VEB Operating Instructions Manual

Setting the Channels and Clock

Preparation:
• Turn on the mains for the television (and connected
equipment) and select the appropriate
AV input to suit the connections to this unit.
• These are the first settings you make upon buying the
unit. You don't need to make these settings again.
to turn the unit on.
DVB Auto-Setup starts. The unit will
search for the digital terrestrial channels.
This takes about 5 minutes.
Power Save Function:
e , r to select "On" or "Off",
then
– Set to "On" to reduce power
consumption in standby mode.
– Refer to the following chart for the
Power Save function features when the unit is turned off.
Power Save
Power consumption
Watching the picture from the
satellite receiver connected to
the AV2 input terminal
Startup time
Front display
e.g., Guide Plus+ list is displayed within 1 second after [GUIDE] is pressed while the unit is off.
When setup has completed, the confirmation screen appears.
The Owner ID settings screen appears.
q and press the numbered
buttons to enter your choice
of a 4-digit PIN number.
Make a note of the PIN number (don't
forget), as it is not possible to return to
the factory preset.
to store the PIN number.
TV's remote control
DVB Auto-Setup
Please wait ! Ch 21
Prog. Channel Service Name Net ID TS ID
1 23 BBC ONE
2 23 BBC
RETURN : to cancel
RETURN
Power Save
On : Minimise standby power
consumption, without
Quick Start function and
AV2 Loop-through in standby.
Off : With Quick Start
SELECT
function and AV2 Loop-through
in standby.
OK
RETURN
On Off
Approx. 2 W Approx. 22 W
Can not do Can do
Not quick Quick
Turns off
(The clock display Stays lighted
disappeared.)
Owner ID
PIN number
Name
House No.
Postcode
RETURN
RETURN : leave
(Continued on the next page)
68
Quality
12302 12289 9
12302 12289 9
On
Off
9
Tips
To cancel Auto-Setup
Press [RETURN].
• If the unit displays "No stations found !"
Press [ q ] to select "No" and press [OK].
Go to step 2. After you have performed
steps 2-bl, turn off the unit and confirm
the cable or aerial input is connected
to the RF IN terminal. Restart the Auto-
Setup again (➔ 79).
• If the clock setting menu appears or the
clock is not correct, set the clock manually
(➔ 14).
Restarting the Auto-Setup (➔ 79)
To correct the PIN number
1. Press [ w , q ] to select the digit.
2. Press the numbered buttons to enter the
digit.
• When this unit is not operated for
approximately 5 minutes while the screen
is being displayed, the screen saver may
be displayed.
You can turn this function off (➔ 82,
"Screen Saver").
13
RQT9089