Basic Connection; Connecting To A Television Only - Panasonic Diga DMR-EX98VEB Operating Instructions Manual

Basic Connection

Use of the RF coaxial cable
To prevent interference patterns from appearing on your TV, use only the supplied RF coaxial cables when you
connect this unit to your TV and aerial outlet or aerial cable.
• Keep the RF coaxial cables as far away as possible from other cables.
• Do not roll up the RF coaxial cables.
Before connection, turn off the mains for all connected equipment and read the appropriate operating instructions.
Be sure to read the Caution for AC Mains Lead on page 3.

Connecting to a Television only

To household
mains socket
To household
mains socket
Step
4
Use one of the RF coaxial cable (black or grey) to connect this unit's RF IN terminal to your aerial socket or
aerial cable.
RF coaxial cable (supplied) from the aerial socket or aerial cable to the "RF IN" on the unit.
RF coaxial cable (supplied, black) from the "RF OUT" on the unit to the "RF IN" on the TV.
21-pin Scart cable (not supplied) from the "AV1 (TV)" on the unit to the "AV" on the TV.
AC mains lead (supplied) from the "AC IN~" on the unit and the TV to a household mains socket.
After completing the above connections, proceed to the TV Tuning (➔ 13).
21-pin Scart terminal
The 21-pin Scart terminal transmits both input
and output signals for picture and sound.
TVs equipped with the same type of terminal
can be connected here.
This type of terminal is also called Peritel,
Euro Connector and Euro AV.
• When the unit is connected to a
Q Link-compatible TV with a fully wired 21-pin
Scart cable, you can use convenient functions
of Q Link.
1 3 5 7 9 11 13 15 17
2 4 6 8 10 12 14 16 18
10
RQT9089
Step
4
AV OUT
COMPONENT VIDEO OUT
Y P P
B R
OPTICAL
AC IN
DIGITAL AUDIO OUT R-AUDIO-L VIDEO
(PCM/BITSTREAM)
OUT
Rear of this unit
To the aerial
AV1 Scart terminal (TV) V1 Scart terminal (TV)
1
2
3
4
5
6
7
8
9
10 Q Link control signal
11 Green output
12 Reserved
19
13 Red ground
14 Blanking ground
21
15 Red output / chrominance output
16 Blanking output
17 Video output ground
18 Video input ground
20
19 Video output / luminance output
20 Video input
21 Ground
AV
RF IN
Rear of TV
Step
3
DMR-EX98VEBK DMR-EZ98VEBK
PR 0 0 0 0 01010 PR 0 0 0 0 01010
SER NO. SER NO.
RF
IN
S VIDEO
RF
OUT
AV 2 (EXT) AV 1 (TV)
RF coaxial cable (supplied, grey)
Step
1
or
RF coaxial cable (supplied, black)
Step
1
Connections other than the 21-pin Scart cable
Audio output CH2 (R)
Audio input CH2 (R)
Audio output CH1 (L)
Audio ground
Blue ground
Audio input CH1 (L)
Blue output
Switching voltage output
Green ground
Step
2
The RF coaxial cable cannot
be used for showing pictures
from the unit. The unit must
be connected using another
method, e.g. 21-pin Scart
cable to show pictures from
the unit on the television set.
To this unit
RF
IN
87–88
AV2 Scart terminal (EXT) V2 Scart terminal (EXT)
1 Audio output CH2 (R)
2 Audio input CH2 (R)
3 Audio output CH1 (L)
4 Audio ground
5 Blue ground
6 Audio input CH1 (L)
7 Blue input
8 Switching voltage input
9 Green ground
10 Reserved
11 Green input
12 Reserved
13 Red ground
14 Blanking ground
15 Red input / chrominance input
16 Blanking input
17 Video output ground
18 Video input ground
19 Video output
20 Video input / luminance input
21 Ground