Panasonic KX-TG7100FX Operating Instructions Manual page 40

TG7100-7120FX(e-e).book Page 40 Thursday, August 10, 2006 10:32 AM
Useful Information
Problem
Noise is heard during a call.
The handset/base unit stops
working while being used.
Pressing {R} does not
display/dial the last number dialled.
The handset beeps intermittently
and/or 7 flashes.
I fully charged the batteries, but
7 still flashes.
Caller information is not displayed. L You must subscribe to Caller ID service.
While viewing caller information,
the display returns to standby
mode.
I cannot register a handset to the
base unit.
40
Cause & solution
L You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources, such
as antennas and mobile phones.
L Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
L The redialled number was more than 24 digits long.
Redial the number manually.
L Fully charge the batteries (page 9).
L Clean the charge contacts and charge again (page
9).
L It is time to replace the batteries (page 8).
L Consult your service provider/telephone company.
L If your unit is connected to a telephone line with
DSL service, the DSL service may be interfering
with your telephone service. We recommend
connecting a filter to the telephone line between the
base unit and the telephone line jack. Contact your
DSL service provider for more information.
L Do not pause for over 1 minute while searching.
L The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 33).
L You entered the wrong PIN number. If you forget
your PIN, consult your nearest Panasonic service
centre.
L Place the handset and the base unit away from
other electrical appliances.