Base Unit Settings - Panasonic KX-TG7100FX Operating Instructions Manual

TG7100-7120FX(e-e).book Page 19 Thursday, August 10, 2006 10:32 AM

Base unit settings

L Use the handset to customise the base unit.
L When customising the base unit, the current item or setting is indicated by >.
To customise the base unit:
1
{j/OK}
2
Press {^} or {V} to select "Base Unit Setup". i {>}
3
Press {^} or {V} to select the desired item in the base unit settings menu. i {>}
4
Press {^} or {V} to select the desired item in the sub-menu. i {>}
5
Press {^} or {V} to select the desired setting then press {>} or follow the instruction in the
"Feature" column of the chart.
L To exit the operation, press {ih}.
Base unit settings
menu
Ringer Volume
Call Options
Other Options
*1 Change the recall time, if necessary, depending on the requirements of your service
provider/telephone company or PBX.
*2 The default setting will be as follows if you select the following regional codes when
changing the unit's region setting (page 20):
CZ=100 msec.
SK=100 msec.
*3 If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN
to you. If you forget your PIN, consult your nearest Panasonic service centre.
Sub-menu Feature (default setting)
— Base unit ringer volume (Medium)
("Tone"): page 11
Dial Mode
Change the recall time
Recall/Flash
page 20
Call Restrict
Change base unit PIN ("0000").
Base Unit PIN
– Enter the current 4-digit base unit PIN.
i Enter the new 4-digit base unit PIN.
i {j/OK}
("Off"): page 33
Repeater Mode
Change the unit's region setting ("EG"):
Country
page 20
Base Unit Settings
*1 *2
("600 msec." ).
*3
19