Philips Fax Machine Manual page 23

Only use this function when absolutely necessary. If
you are satisfied with your changes to the factory
settings you should not use this function.
Function 45 Service code is used to delete some or all of your
changes to the factory settings. This function enables you to
partially or fully reconfigure your device. It is especially helpful if
you have modified settings but find that your fax machine does
not respond as expected.
After deleting some or all of your custom settings please rerun
Easy Install.
The following codes are at your disposal:
This code erases all your modifications to the factory settings.
The fax machine will therefore react in exactly the same way as
on first installation.
When you enter this code, all your entered settings and data will
be erased, except for:
• stored short dial numbers
• stored telephone book numbers
• your name
• your telephone number
Select MENU 45 and press OK. Enter the service code
(7117 or 7140). Press OK.
With </> you can select whether you really want to delete
your settings. Confirm with OK. Your fax machine will be
reset to its original configuration.
Before opening the fax machine, make sure that you
are electrically discharged by e.g. touching the metal
housing of a grounded appliance, a water pipe or
radiator.
Use a soft, fluff-free cloth lightly moistened with a
little alcohol (96%). You can also use a special cloth
for cleaning fax machines, which is available on the
market. Do not allow any moisture to penetrate
inside the device.
Carefully remove the scanner by pulling it upwards on both
sides.
Place the scanner in front of you with the scanning glass
surface face up.
Gently wipe the glass surface with a soft cloth (A).
Before you re-install the scanner, also wipe the scanner
compartment.
Place the scanning device face front into the fax machine.
Press both sides of the scanner down until you hear a
definite click.