Panasonic KX-TG8561E Operating Instructions Manual page 38

Programming
Note:
R To register a handset to another base unit
or to the same base unit again, see
page 37.
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
(middle soft key) #138
2
MbN: Select the desired setting. a
a M N
Note:
R After turning the repeater mode on or off,
is displayed on the handset
momentarily. This is normal and the
handset can be used once
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Press and hold M
until the registration tone sounds.
R The next step must be completed
within 90 seconds.
38
TG8561E(en-en)_0420_ver101.pdf
is displayed.
N for about 5 seconds,
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
38
2
DECT repeater:
Connect the AC adaptor, then wait until
the indicator and
green.
3
Base unit:
To exit the registration mode, press M
R The registration tone stops.
2012/04/20 14:29:12
indicator light
N.