Table of Contents
Advertisement
TG2361JX.book 64 ページ ２００９年１２月１７日 木曜日 午前１１時５５分
Remote Operation from a Touch Tone Phone
While outside, you can operate the Answering System from any touch tone phone.
A synthesized voice menu will guide you through the Answering System (p. 65).
• To skip the voice menu and operate the unit directly, see page 66.
Summary of remote operation
Call your unit from a touch tone phone.
Enter your remote code (see below) during or after
the greeting message.
• The number of new messages is heard, and the
new messages will be played.*
After 3 seconds, the voice menu will start (p. 65).
Follow the menu or enter direct commands (p. 66).
To end remote operation, hang up.
• The unit will announce the remaining recording time after playback if it is less than
3 minutes.
• The messages are saved.
* If "No new messages" is announced, the unit has only old messages.
If "No messages" is announced, the unit has no messages.
Remote Code
The remote code prevents unauthorized people from accessing your unit and
listening to your messages. Choose any 2-digit number (00–99) for your remote
code. The factory preset remote code is "11". If you do not program your own
remote code, you can use "11".
Press [MENU].
1
Scroll to "Initial setting" by pressing [d] or [B], then press
2
Select.
3
Press Select at "Set answering".
Scroll to "Remote code" by pressing [d] or
4
[B], then press Select.
5
Enter a 2-digit remote code (00–99).
Press Save, then press [OFF].
6
To confirm the remote code, repeat steps 1 to 4.
• The remote code is displayed. When finished, press [OFF].
64
u
u
u
Handset
Set answering
Back
Select
K
L
dB
Remote code
Back
Select
L
K
dB
Remote code
:11
Back
Save
K
L
Advertisement
Table of Contents
