Others - Panasonic SC-HC57 Operating Instructions Manual

Play timer
You can set the timer so this unit turns on at a certain
time every day.
Preparation
Set the clock ( 14).
∫ Setting the timer
1
Press [SETUP] repeatedly to select
"TIMER ADJ" and then press [OK].
2
Press [3, 4] to set the starting time
("ON TIME") and then press [OK].
3
Press [3, 4] to set the finishing time
("OFF TIME") and then press [OK].
≥ To display the timer settings, press [SETUP] repeatedly to
select "TIMER ADJ" and then press [OK] once.
(During standby, press [iPod MENU, DISPLAY] twice.)
≥ The music source and volume will also be displayed if the
timer is turned on. ( below)
∫ Turn the timer on
1
Select the music source*
volume.
2
Press [SETUP] repeatedly to select
"TIMER SET" and then press [OK].
3
Press [3, 4] to select "SET" and then press [OK].
≥ "F" is displayed.
4
Press [Í] to turn the unit off.
*1: "CD", "USB", "IPOD" and "FM" can be set as the music
source.
≥ This unit can be used as normal after the timer is set,
however:
≥ Turn the unit to standby mode before the timer start time.
≥ Even if the audio source or the volume is changed, the
timer will still use the audio source and volume that was
set when the timer was turned on.
≥ To turn the timer off, select "OFF" in step 3.
≥ The unit will turn on at the preset time, with the volume
increasing gradually to the preset level.
Sleep timer
The sleep timer can turn the unit off after a set time.
1
Press [SETUP] repeatedly to select "SLEEP" and
then press [OK].
2
Press [3, 4] to set the time (in minutes) and then
press [OK].
"SLEEP 30" ,. "SLEEP 60" ,. "SLEEP 90" ,. "SLEEP 120"
^------------------------.
OFF (Cancel)
≥ The remaining time is indicated on the unit's display except
when other operations are performed.
≥ The play timer and sleep timer can be used together. The
sleep timer always has priority.
and set the desired
1
(------------------------J

Others

Automatic standby
As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for 30 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select "AUTO OFF"
and then press [OK].
2
Press [3, 4] to select "OFF" and then press [OK].
≥ To turn automatic standby on, select "ON" in step 2.
≥ This setting cannot be selected when "FM" is the source.
Display brightness
The brightness of this unit's display can be changed.
1
Press [SETUP] repeatedly to select "DIMMER"
and then press [OK].
2
Press [3, 4] to select "ON" and then press [OK].
To cancel the dimmer, select "OFF" in step 2.
Changing the main unit and
remote control code
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [CD] to select "CD".
2
Press and hold [CD] on the main unit and [3] on
the remote control until the main unit's display
shows "REMOTE 2".
3
Press and hold [OK] and [3] on the remote control
for at least 4 seconds.
To change the mode back to "REMOTE 1", repeat the steps
above by replacing [3] with [4].
15
RQT9714