Advertisement
5 Frequently asked questions
Question
What kind of power outlet
should I connect the AC
adaptor to?
Why is w flashing?
Why is the handset display
blank?
What should I do when the
handset does not turn on?
How long should I charge new
batteries?
How long is the battery
operating time?
When should I replace the
batteries?
What is a PIN?
What do I need to do to
display caller information?
Cause & solution
Connect the AC adaptor to a 220–240 V outlet.
L The handset is too far from the base unit. Move closer.
L The AC adaptor is not connected. Check the
connections.
L The handset is not registered to the base unit. Register it.
" (centre of joystick) i m i # i
"Registration" i # i "Register H.set" i
# i Select a base unit number. i # i Press
and hold {x} on the base unit for about 3 seconds, until the
registration tone sounds. i Wait until "Enter Base
PIN" is displayed. i Enter the base unit PIN (default:
"0000"). i #
The handset is not turned on. To turn the power on, press
{ih} until a short beep sounds.
L Make sure that the batteries are installed correctly.
L Fully charge the batteries.
L Clean the charge contacts and charge again.
Charge the batteries for about 7 hours.
When you are using fully-charged Ni-MH batteries;
Talking:
14 hours max.
Standby: 150 hours max.
L Battery operating time may be shortened over time
depending on usage conditions and ambient
temperature.
If the batteries are fully charged until ! is displayed, but #
is displayed after a few calls, replace the batteries with new
ones.
The PIN is a 4-digit number that must be entered in order
to change certain handset and base unit settings. The
default PIN for both the handset and base unit is "0000".
You need to subscribe to Caller ID service. Consult your
service provider for details.
–
–
4
Advertisement
