Table of Contents
Advertisement
Setup for Input Signals
Select Signal from the "Setup" menu during RGB or PC input signal mode.
The following operation methods are the same for both the Signal [RGB]
and Signal [PC].
Sync
Setting RGB sync signal:
Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT).
H&V:
The H and V sync signals are input from the HD/VD connector.
on G:
Uses a synchronized signal on the Video G signal, which is input
from the G connector.
on VIDEO: Compatible with the scart plug (Europe)
The composite video signal input from the VIDEO input terminal is
used by dividing the sync signals.
Setting PC sync signal:
Confirm that the input is set to PC INPUT (this setting is valid only for PC INPUT).
H&V: The H and V sync signals are input from the HD/VD connector.
on G: Uses a synchronized signal on the Video G signal, which is input from the G connector.
Pull-in range
Sets the width for different frequencies.
(This setting is the same for both Signal [RGB] and Signal [PC].)
Clamp position
Adjusts the clamp position.
The following operation methods are the same for "Signal" menu during
Component, RGB and PC input signal mode.
Normally, these adjustments are set to appropriate levels and therefore, do not
need to be altered.
H-Freq (kHz)/V-Freq (Hz)
Displays the H (Horizontal)/V (Vertical) frequencies.
This display is valid only for RGB input and PC input.
Display range:
Horizontal 15.5 - 110 kHz
Vertical 48 - 120 Hz
36
Press to select each item.
Press to adjust.
Signal
Sync
H & V
Narrow
Pull-in range
Clamp position
H-Freq.
31.5
kHz
V-Freq.
60.0
Hz
[ Component ]
Signal
Clamp position
Signal
Sync
H & V
Pull-in range
Narrow
CLamp position
H-Freq.
31.5
kHz
V-Freq.
60.0
Hz
Sync
H & V
Sync
on G
Sync
on VIDEO
Pull-in range
Narrow
Pull-in range
Wide
Clamp position
H-Freq.
31.5
kHz
V-Freq.
60.0
Hz
[ RGB ]
[ PC ]
Advertisement
Table of Contents
