Sync; Pull In Range; Clamp Position; [H-Freq. (Khz)/V-Freq. (Hz)] - Panasonic TH-50PHW3 Operating Instructions Manual

SET UP for Input Signals
Select SIGNAL from the "SET UP" menu during RGB or PC input signal mode.
Press to select each item.
Press to adjust.
The following operation methods are the same for both the SIGNAL [RGB]
and SIGNAL [PC].
SYNC
t SIGNAL [ COMPONENT ]
II_ POSITION
SIGNAL I RGB ]
SYNC <_{_
PULL-INRANGE <_
CLAMP POSITION
H-FREQ. _ kHz
V-FREQ. _ Hz
SIGNAL [ PC ]
¢_co
SYNC <1 _ "
PULL-IN R ANGE q _
CLAMP P OSITION
H-FREQ. _
kHz
V_FREQ. _
Hz
Setting RGB sync signal setting:
(. SYNC ,__ D)
Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT).
H&V: The H and V sync signals are input from the HD/VD (BNC) connector. ( SYNC _3_ D)
ON G: Uses a synchronized signal on the Video G signal, which is input ,_
from the G (BNC) connector.
v
ON VIDEO: Compatible with the scart plug (Europe) ( SYNC 4_)
The composite video signal input from the VIDEO input terminal is
used by dividing the sync signals.
Setting PC sync signal setting:
Confirm that the input is set to PC INPUT (this setting is valid only for PC INPUT).
H&V: The H and V sync signals are input from the HD/VD (BNC) connector.
ON G: Uses a synchronized signal on the Video G signal, which is input from the G (BNC) connector.
PULL IN RANGE
Sets the width for different frequencies.
(This setting is the same for both SIGNAL [RGB] and SIGNAL [PC].)
CLAMP POSITION
( PULL IN RANGE <_b)
$
(_PULL IN RANGE q_L>)
Adjusts the clamp position.
The following operation methods are the same for "SIGNAL" menu during
COMPONENT, RGB and PC input signal mode.
Normally, these adjustments are set to appropriate levels and, therefore, do not
need to be altered.
_CLAMP POSITION m )
H-FREQ (kHz)/V-FREQ (Hz)
Displays the H (Horizontal)/V (Vertical) frequencies.
This display is valid only for RGB input and PC input.
Display range:
Horizontal 15.5 110 kHz
Vertical 48- 120 Hz
H-FREQ. _ kHz
V-FREQ. _ Hz
32