Sync; Pullin Range; Clamp Position; [H-Freq. (Khz)/V-Freq. (Hz)] - Panasonic TH-42PW3 Operating Instructions Manual

SET UP for Input Signals
Select SIGNAL from the "SET UP" menu during RGB or PC input signal mode.
Press to select each item.
Press to adjust.
The following operation methods are the same for both the SIGNAL [RGB]
and SIGNAL [PC].
SIGNAL [ RGB ]
C SYNC <_ _ D"
(,PULL-IN RANGE <J Bm_,_L='W_ D_
( CLAMP P OSITION ,'
H-FREQ. _ kHz
V-FREQ. _ Hz
SIGNAL [ PC]
==1:=
( SYNC < D_
C PULL-INRANGE
q_b)
CLAMP POSITION
H-REG._ kHz
V-FREQ. _ Hz
SYNC
Setting RGB sync signal setting:
Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT).
H&V: The H and V sync signals are input from the HD/VD (BNC) connecter.
ON G: Uses a synchronized signal on the Video G signal, which is input
from the G (BNC) connector.
ON VIDEO: Compatible with the scart plug (Europe)
The composite video signal input from the VIDEO input terminal is
used by dividing the sync signals.
( SYNG qi H&V I_)
C SYNC _]_
D)
(,SYNC ,_1 ON VIDEO iD)
Setting PC sync signal setting:
Confirm that the input is set to PC INPUT (this setting is valid only for PC INPUT).
H&V: The H and V sync signals are input from the HD/VD (BNC) connector.
ON G: Uses a synchronized signal on the Video G signal, which is input from the G (BNC) connector.
PULLIN RANGE
Sets the width for different frequencies,
(This setting is the same for both SIGNAL [RGB] and SIGNAL [PC].)
CLAMP POSITION
( PULL IN RANGE <31NARROW
ID)
( PULL IN RANGE <]1 WIDE ID)
Adjusts the clamp position.
The following operation methods are the same for "SIGNAU' menu during,
RGB and PC input signal mode.
Normally, these adjustments are set to appropriate levels and, therefore, do not
need to be altered.
(CLAMP POSITION m )
H-FREQ (kHz)/V-FREQ (Hz)
Displays the H (Horizontal)/V (Vertical) frequencies.
This display is valid only for RGB input and PC input.
Display range:
Horizontal 15.5 - 1 10 kHz
Vertical 48 - 120 Hz
H-FREQ. _ kHz
V-FREQ. _ Hz
32