Sync; Pullin Range; Clamp Position; [H-Freq (Khz)/V-Freq (Hz)] - Panasonic TH-37PWD4 Operating Instructions Manual

SET UP for Input Signals
Select SIGNAL from the "SET UP" menu during RGB or PC input signal mode
Press to select each Ilem
Press to adjust
The following operation methods are the same for both the SIGNAL [RGB]
and SIGNAL [PC]
I SfGNAL == [ ROB ]
{ PULL-IN RANGE _%31
(CLAMP POSITION m )|
I SIGNAL
( CLAMP POSITION
d
I COMPONENT .]
I
! SIGNAL === [ PC ] !
llc
S YNC _ m P)l
II el
_1 ( CLAMP_ POSITION ,_)1
SYNC
Setting RGB sync signal
(SYNC
,_1 H&V
tP)
Confirm that the input ts set LoRGB INPUT (thts settmg is valid only for RGB INPUT)
H&V The H and V sync stgnals are Input from the HDND connector ( SYNC ,_1 ONO ID)
ON G Uses a synchronized stgnal on the Video G stgnal, which IS Input
from theG connector
ON VIDEO Compatible with the start plug (Europe) (SYNC (31ONVIDEO ID)
The composite vtdeo stgnal mpuL from the VIDEO inpuLtermmal is
used by dividmg Lhesync stgnale
Setting PC sync signal
Confirm that the input Is set to PC INPUT (this setting Is valid only for PC INPUT)
H&V The H and V sync stgnals are mput from the HD/VD connector
ON G Uses a synchronized signal on the Video G signal, which is Input from the G connector
PULLIN RANGE
Sets the width for different frequencies.
(This setting IS the same for both SIGNAL [RGB] and SIGNAL [PC] )
CLAMP POSITION
(PULL IN RANGE (!l NARROW ID)
(.PULLIN RANGE 41 WIDE Ib)
Adjusts the clamp position.
The followmg operation methods are the same for "SIGNAL" menu durmg
COMPONENT, RGB and PC Input sLgnal mode
Normally, these adjustmenLs are set to appropriate levels and, Lheretore,
do not need to be altered
( CLAMP POSITION ' )
H-FREQ (kHz)/V-FREQ (Hz)
Displays the H (Honzontal)/V (Vertical) frequencies.
Th=sdJsplay is vahd only for RGB mput and PC mput
Display range
Honzenlal 15 5 - 110 kHz
Vertical 4B - 120 Hz
H-FREQ _ kHz
V-FREQ _ Hz
39