Hardware Flow Control; Software Flow Control - Hand Held Products 4410, 4710 User Manual

Hardware Flow Control

When hardware flow control is On , the software checks for a CTS signal before
sending data. This option is useful when your application supports the CTS
signal.
On * Off

Software Flow Control

This allows control of data transmission from the Imager using software
commands from the host device. When this feature is turned Off , no data flow
control is used. When Data Flow Control is turned On , the host device suspends
transmission by sending the XOFF character (DC3, hex 13) to the Imager. To
resume transmission, the host sends the XON character (DC1, hex 11). Data
transmission continues where it left off when XOFF was sent.
On
* Off
IMAGETEAM™ 4410/4710 User's Guide 2 - 13