Cable Pinouts - Hand Held Products 4410, 4710 User Manual

Cable Pinouts

RS-232 Output, External Power
Decoded output data format is provided at the modular connector in the
Imager.Interface cables normally supplied with the Imager are terminated with a
10 pin modular plug (P1) and a 9 pin Type D connector (P3) that is compatible
with all Hand Held Products decoders and terminals. See chart below. (The
power pigtail applies to serial wedge cable, which is not shown.)
P1
Pin 1
10 Pin Modular Plug
P1 connects to the Imager.
P1
1 NC
2 Ground
3 +5VDC
4 Ground
5 RXD
6 TXD
7 +5VDC
8 RTS
9 CTS
10 TRIG
SH
1. The voltage requirements for external trigger signal are Logic Low <= .3 VDC and
Logic Hig >= 1.8 VDC.
10 - 6
Pin 10
P3
9 Pin Type D Female
P3 connects to your terminal.
No Connection
Supply Ground
Power Connection
Supply Ground
Receive Data - Serial Data to Imager
Transmit Data - Serial Data from Imager
Power Connection
Request to Send Data
Clear to Send Data
External Trigger
Drain Wire (Shield)
1
IMAGETEAM™ 4410/4710 User's Guide
P2
Power Pig Tail
P2 connects to the
external power
supply.
Inner
View B-B
5
9
View A-A
P2
Inner
Outer
P3
Outer
1
6
|
0
5
Red
3 Black
Green
2
8
Blue
7
Brown
SH