Trigger Timeout - Hand Held Products 4410, 4710 User Manual

Note: ‡
Save are required after reading this programming symbol. See "Decimal
to Hex to ASCII Conversion Chart" on page 2-36, and the Programming
Chart (inside back cover).

Trigger Timeout

Use this selection to set a timeout (in quarter seconds) of the Imager's trigger.
Once the imager has timed out, it must be triggered again either serially (see
"Serial Triggering" on page 2-14), or manually. Set the Trigger Timeout to 00 if
you don't want a Trigger Timeout. Default setting = 120 seconds
IMAGETEAM™ 4410/4710 User's Guide
A one to three digit decimal number and
Set Timeout ‡
2 - 15