Linear Symbologies
Code 93
Code 93
On
Message Length
The message length selection is used to set the valid reading length of the bar code.
If the data length of the scanned bar code doesn't match the valid reading length, the
scanner will not read the symbol. You may wish to set the same value for minimum
and maximum length to force the scanner to read fixed length bar code data. This
helps reduce the chances of a misread.
EXAMPLE: Decode only those bar codes with a count of 9-20 characters.
Min. length = 09
EXAMPLE: Decode only those bar codes with a count of 15 characters.
Min. length = 15
Minimum
Message Length
The desired message length and Save must be input after reading this
programming symbol. Refer to the Programming Chart (inside back cover).
3 - 14
< Default All Code 93 Settings >
IMAGETEAM™ 4410/4710 User's Guide
Max. length = 20
Max. length = 15
* Off
Maximum
Message Length