Log Installation - FPI U32-LP2 Owners & Installation Manual

LOG SET
INSTALLATION
Read the instructions below carefully
and refer to the diagrams.
broken do not use the unit until they are
replaced. Broken logs can interfere with
the pilot operation.
The gas log kit contains the following:
a) 02-43 Rear Log
b) 02-45 Front Right Log
c) 02-56 Middle Left Log
d) 02-46 Left Top Log
e ) 02-47 Center Log
f) 02-48 Middle Right Log
g) 02-44 Front Left Log
h) Embers
i) Rockwool
j) Vermiculite
Note: Install Optional Brick Panels prior
to installing logs.
The "02" refer numbers (i.e. 02-43) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite around the firebox
base. Take some of the embers (approx.
1/3 of the bag) and sprinkle over the ver-
miculite.
Vermiculite and
Vermiculite and
embers.
embers.
U32-2 FPI Direct Vent Gas Insert
3) Place Rear Log A)02-43 on the two pins on
the rear log support.
If logs are
902-227
902-229
902-230
Pins on Rear Log Support
902-231
902-232
4) Place Front Right Log B)02-45 on the two
902-226
pins as shown.
902-228
902-154
902-153
902-179/21
5) Place the Middle Left Log C)02-56 on the
two pins as shown.
C)02-56
Logs A)02-43, C)02-56,
and B)02-45 in position
Vermiculite and
embers.
6) Place the Left Top Log D)02-46 on the pin on
A)02-43
7) Place the notch in Center Log E)02-47 over
B)02-45
Logs D)02-46 and E)02-47 in position.
8) Position notch in Front Right Log F)02-48 on
Notch
INSTALLATION
Log C)02-56 and on top of the cutout on Log
A)02-43.
D)02-46
C)02-56
Pin
Cutout
Log B)02-45 and across the cutout on Log
A)02-43.
E)02-47
A)02-43
B)02-45
Notch
Cutout
Log E)02-47 and push the bottom right edge
against the bracket on the burner tray and
the front edge of the rear burner.
F)02-48
B)02-45
A)02-43
Bracket
9