Changing The Scanning Mode - JVC UX-S77 Instructions Manual

To connect the AM loop antenna
1 Hold
2 Insert
• If the AM loop antenna wire or speaker cords are covered
with vinyl, remove the vinyl to expose the tip of the
antenna by twisting the vinyl.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
To connect the speaker cords
Connect the right speaker to the RIGHT terminals, and the
left speaker to the LEFT terminals.
1 Open
When connecting the speaker cords, match the polarity of
the speaker terminals:
• For LOW terminals: Red cord to (+) and black cord to (–).
• For HIGH terminals: Grey cord to (+) and blue cord to (–).
The speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the
TV's main power switch or unplug it before installing
the speakers.
Then wait at least 30 minutes before turning on the TV's
main power switch again.
Some TVs may still be affected even though you have
followed the above. If this happens, move the speakers
away from the TV.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT allow the conductor of the speaker
cords to be in touch with the metallic parts of
the System.
6
3 Release
2 Insert 3 Close
To connect digital audio
Before connecting optical digital cord, remove the
protective cap from the DVD OPTICAL DIGITAL OUT
terminal.
To select the video signal
When connecting a TV, you can use either one of the video
output terminals—COMPONENT or AV OUT.
After connecting the TV, set the video signal type correctly
for your TV.
RGB
VIDEO
Y/C OUT
SELECT
Y/C Select for sending S-Video singles through the
AV OUT terminal or for sending component
video signals through the COMPONENT jacks.
RGB Select for sending the composite video signals
or RGB signals through the AV OUT terminal.

Changing the Scanning Mode

This System supports progressive scanning.
If you connect a progressive TV through the COMPONENT
jacks, you can enjoy a high quality picture from the built-in
DVD player by selecting "PROGRE."
PROGRESSIVE
0
(at the same time)
PROGRE
Progressive scanning. For a progressive
TV.
INTER Interlaced scanning. For a conventional
TV.
D V D
O P T
D I G
I C A
I T A L
L
O U T
P C M
/ S T R
E A M
Remote
ONLY
PROGRE
INTER