Audio Setup Menu - JVC UX-S77 Instructions Manual

PICTURE SOURCE
You can obtain optimal picture quality by selecting an
appropriate option—picture source type (either video source
or film source).
Select one of the following:
AUTO: Normally select this.
When playing back a disc containing both video
and film sources, the System automatically
changes the processing to match it to the picture
type (film or video source) of the current chapter.
FILM: To play a film source disc.
VIDEO: To play a video source disc.
SCREEN SAVER
You can activate or deactivate screen saver while operating
the built-in disc player.
Select one of the following:
ON: The picture on the TV becomes dark when no
operation is done for about 5 minutes.
OFF: To cancel the screen saver.
FILE TYPE
If both audio tracks (MP3 or WMA files) and still picture
(JPEG files) are recorded on a disc, you can select which to
play.
Select one of the following:
AUDIO: To play MP3/WMA files.
STILL PICTURE: To play JPEG files.
36
7

AUDIO Setup Menu

You can adjust the sound settings of the System.
AUDIO
DIGITAL AUDIO OUTPUT
DOWN MIX
D. RANGE COMPRESSION
SELECT
USE
TO EXIT, PRESS [ SET UP ] .
ENTER
DIGITAL AUDIO OUTPUT
When using the digital output terminal on the rear, set this
correctly according to the connected component.
Select one of the following:
PCM ONLY: To connect to a linear PCM digital
equipment.
DOLBY DIGITAL To connect to a Dolby Digital decoder
/PCM: or an amplifier with a built-in Dolby
Digital decoder.
STREAM/PCM: To connect to a DTS decoder or an
amplifier with a built-in DTS decoder.
• See also "OPTICAL DIGITAL OUT Signals" on page 46.
DOWN MIX
When using the digital output on the rear, set this correctly
according to the connected component.
When playing a multi-channel DVD, the System converts
the signals into 2 channels properly.
Select one of the following:
DOLBY To connect an amplifier with the Dolby
SURROUND: Pro Logic decoder.
STEREO: To connect a conventional stereo
amplifier, receiver, MD player, TV, etc.
STREAM/PCM
DOLBY SURROUND
AUTO
TO SELECT. USE ENTER TO CONFIRM