Maytag MAT14PRAWW1 Installation Instructions Manual page 11

CONTROL SET-UP PROCEDURES
IMPORTANT: Read all instructions before operating.
The lower fabric setting key pads and the digital display are used
to set up the controls. The display can contain 4 numbers and/or
letters and a decimal point. These are used to indicate the set-up
codes and related code values available for use in programming
the washer.
How to use the key pads to program the controls
1. The LOWER LEFT key pad is used to adjust the values
associated with set-up codes. Pressing the key pad will
increment the value.
Rapid adjustment is possible by holding the key pad down.
2. The LOWER MIDDLE key pad will advance you through the
set-up codes. Pressing the key pad will advance you to the
next available set-up code. Holding the key pad down will
automatically advance through the set-up codes at a rate of
one (1) per second.
3. The LOWER RIGHT key pad is used to select or deselect options.
Start Operating Set-Up
• PD Models: Insert access door key, turn, and lift to remove access door.
• PR Models: Once the debit card reader is installed (according to the
reader manufacturer's instructions), the set-up mode can be entered
by inserting a set-up card (supplied by the reader manufacturer) into
the card slot. If a manual set-up card is not available, manual set-up
mode can be entered by removing connector AA1 on the circuit
board.
IMPORTANT: The console must not be opened unless power is first
removed from the washer. To access connector AA1 :
Unplug washer or disconnect power.
Open console, disconnect plug on AA1, close console.
Plug in washer or reconnect power.
The washer is now in the set-up mode.
Before proceeding, it is worth noting that, despite all of the options
available, an owner can simply choose to uncrate a new commercial
washer, hook it up, plug it in, and have a unit that operates.
SET-UP CODES
• The LOWER MIDDLE key pad will advance from code to code.
• The LOWER LEFT key pad will change the code value.
• The LOWER RIGHT key pad wilt select or deselect options.
FOR PR MODELS: The set-up codes are the same as for the 'PD'
models except where noted.
The set-up code is indicated by the one or two left-hand characters. The
set-up code value is indicated by the two or three right-hand characters.
i-n'_
o___
REGULAR CYCLE PRICE
Represents the numberof quarters (coin1);mayadjustfrom 0-39.
(See VALUE OFC01N 1.)Advance from 0-39 bypressing the LOWER
LEFTkeypad.Factory preset f or 7 quarters = $1.75.
PRMODELS ONLY: Factory presetfor 0 quarters.
Pressthe LOWER MIDDLE keypadonceto advance to nextcode.
WASH LENGTH
This isthe numberof minutesfor WASH.
Choose from 8-20 minutesby pressing the LOWER LEFTkeypad.
--> Pressthe LOWER MIDDLE keypadonceto advance to nextcode.
n-_l I
RINSE CYCLES
o __, I This isthe lengthandtotal numberof rinses.Eachrinseagitationi_
1-4 minutes,witha choiceof 1 or 2 rinses. T he middledigitis the
lengthof rinseagitationandthe rightdigit is the numberof rinses.
Thenumberis changed in the followingsequence (11,21,31,41,
12, 22, 32,42) bypressingthe LOWER LEFTkeypad.
Pressthe LOWER MIDDLE keypadonceto advance to next code.
The DELICATES & KNITS cyclehasa fixedrinseagitationlength
of oneminute.
LOWER MIDDLE keypadonceto advance to nextcode.
CYCLE COUNTER OPTION
Thisoptionis eitherSELECTED 'ON'or NOT SELECTED ' OFF'.
NotSelected 'OFF'.
Selected 'ON' andnotable to be deselected.
Press the LOWER RIGHT keypad3 consecutive times
to select'ON'.Onceselected 'ON' it cannotbe deselected.
LOWER MIDDLE keypadonceto advance to nextcode.
MONEY COUNTER OPTION
Thisoptionis eitherSELECTED 'ON'or NOT SELECTED ' OFF'.
NotSelected 'OFF'.
Selected 'ON'.
Press the LOWER RIGHT keypad3 consecutive times
to select'ON'and3 consecutive times to remove
(NotSelected 'OFF'.) C ounterresetsbygoingfrom 'OFF' t o 'ON'.
Selected 'ON' andnotable to be deselected.
Toselect'ON'andnot ableto bedeselected, f irst select'ON',then
withintwo seconds pressthe LOWER RIGHT key padtwice,the
LOWER L EFT keypadonce, a ndexitthe set-upmode.
--> Pressthe LOWER MIDDLE keypadonceto advance to nextcode.
SPECIAL PRICING OPTION
Thisoptionis eitherSELECTED 'ON'or NOT SELECTED ' OFF'.
NotSelected 'OFF'.
Selected 'ON'.Pressthe LOWER RIGHT keypadonce
forthis selection.
If SPECIAL PRICING OPTION is selected, youhaveaccessto codes'3'
through'9.'.
Pressthe LOWER MIDDLE keypadonceto advance to nextcode.
m
nnn
_'___
_nF"
_'___
Pressthe
inn
_uu
inn
I. Lr-r-r-r-r-r-r-r-_j
laP"
"_-E-E-E-E-E-E-E-E-_
iFn
m
"_nn
_n
i_'_.lU 7
Pressthe
OPTIONS T OUSEIF SPECIAL P RICING ISSELECTED:
SPECIAL CYCLE PRICE
Represents the numberof quarters(coin1):may adjust
from 0-39.(See VALUE OFC01N1.)Advance from 0-39 by
pressing the LOWER LEFT keypad.Factory preset
for 7 quarters= $1.75.
PRMODELS ONLY: Factory presetfor 0 quarters.
LOWER MIDDLE keypadonceto advance to nextcode.
11