Synchronization Status; Displaying Synchronization Status - Avaya G250 Administration

Media gateways
Hide thumbs Also See for G250:
Table of Contents

Advertisement

Setting synchronization
If the Avaya G250 or G350 Media Gateway includes a second MM710 media module, enter the
following additional command:
set sync interface secondary v3
set sync source secondary
If, for any reason, the primary MM710 media module cannot function as the clock
synchronization source, the system uses the MM710 media module located in slot 3 of the
Avaya G350 Media Gateway chassis as the clock synchronization source. If neither MM710
media module can function as the clock synchronization source, the system defaults to the local
clock running on the S8300 Media Server.

Synchronization status

The yellow ACT LED on the front of the MM710 media module displays the synchronization
status of that module.
If the yellow ACT LED is solidly on or off, it has not been defined as a synchronization
source. If it is on, one or more channels is active. If it is an ISDN facility, the D-channel
counts as an active channel and causes the yellow ACT LED to be on.
When the MM710 is operating as a clock synchronization source, the yellow ACT LED
indicates that the MM710 is the clock synchronization source by flashing at three second
intervals.
- The yellow ACT LED is on for 2.8 seconds and off for 200 milliseconds if the MM710
media module has been specified as a clock synchronization source and is receiving a
signal that meets the minimum requirements for the interface.
- The yellow ACT LED is on for 200 milliseconds and off for 2.8 seconds if the MM710
media module has been specified as a synchronization source and is not receiving a
signal, or is receiving a signal that does not meet the minimum requirements for the
interface.

Displaying synchronization status

Use the show sync timing command to display the status of the primary, secondary, and
local clock sources. The status can be Active, Standby, or Not Configured. The status is Not
Configured when a source has not been defined, for example, when there are no T1 cards
installed.
570 Administration for the Avaya G250 and Avaya G350 Media Gateways

Advertisement

Table of Contents
loading

This manual is also suitable for:

G350

Table of Contents