Basic Setup; Automatically Setting Up For Surround Sound (Accueq Room Calibration) - Onkyo TX-SR353 Operating Instructions Manual

3:

Basic Setup

Automatically setting up for surround sound
(AccuEQ Room Calibration)
Place the supplied setup microphone in the listening position,
measure the test tones emitted by the speakers, then the unit
automatically sets the optimum volume level for each
speaker, the crossover frequencies, and the distance from
the listening position. This also enables correction of
distortion caused by the acoustic environment of the room.
CAUTION
• The test tones used in the AccuEQ Room Cal. setup are
output at high volume.
Important
• The OSD will not appear if you have connected using the
composite output to your TV. Use HDMI connections for
AccuEQ Room Cal. setup.
The AccuEQ Room Cal. setup will overwrite any existing
•
speaker settings you've made.
• Before using the AccuEQ Room Cal. setup, the USB input
should not be selected as an input source.
QUICK MENU QUICK MENU
RECEIVER RECEIVER
BD/DVD BD/DVD CBL/SAT STRM BOX CBL/SAT STRM BOX
AUDIO SEL AUDIO SEL
LATE NIGHT
1
Switch on the receiver and your TV.
2
Switch the TV input to the input that connects this
receiver to the TV through the corresponding HDMI
cable.
3
Connect the microphone to the SETUP MIC jack on the
front panel.
Make sure there are no obstacles between the speakers
and the microphone.
TUNING PRESET
HOME ENTER RETURN
TUNER USB
SURR SURR DSP DSP
TREBLE
If you have a tripod, use it to place the microphone so
that it's about ear level at your normal listening position.
Otherwise, place the microphone at ear level using a
table or a chair.
MASTER VOLUME
SETUP MIC USB
5V / 0.5A
AV RECEIVER TX- SR353
16
4
BD/DVD
Press button on the remote control to switch
to BD/DVD entry.
5
Press button.
The Setup appears on your TV. Use
ENTER
on the remote control to navigate through the
screens and select menu items. Press
current menu.
• Press at any time to exit the Setup. If you cancel
the AccuEQ Room Cal. setup at any time, the receiver
automatically exits and no settings will be made.
The screensaver automatically starts after three
•
minutes of inactivity.
6
Select "AccuEQ Room Cal." from the Setup, then press
ENTER.
Setup
1.AccuEQ Room Cal.
2.Manual SP Setup
3.Input Assign
4.Auto Power Down
5.HDMI Setup
Return
7
ENTER
Press again.
• MIC IN blinks when the microphone is not connected
to jack.
SETUP MIC
Try to be as quiet as possible after pressing ENTER.
The system outputs a series of test tones to establish the
ambient noise level.
8
Follow the instructions on-screen.
• Make sure the microphone is connected.
• Make sure the subwoofer is on and the volume is
turned up.
• See below for notes regarding background noise and
other possible interference.
2
4
/ // and
to exit the
31